Loading ...
Loading ...
Loading ...
35
PRODUCT CARE
2. The brush guard assembly may now be removed (Figure 58).
Figure 58
NOTE: The FastAttach™ brackets may be left in place for use with
other FastAttach™ attachments. Contact your authorized service
dealer for a complete list of products and availability.
CHANGING THE TRANSMISSION DRIVE BELT
Several components must be removed and special tools used in
order to change the tractor’s transmission drive belt. Contact
your authorized service dealer to have the transmission drive
belt replaced.
TROUBLESHOOTING
WARNING
Before performing any type of maintenance/service, disengage all controls and stop the engine. Wait until all moving
parts have come to a complete stop. Allow the engine to cool. Disconnect spark plug wire(s) and negative battery cable to
prevent unintended starting. Always wear safety glasses during operation or while performing any adjustments or repairs.
This section addresses minor service issues. To locate the nearest authorized service center consult the separate supplement
sheet for contact information.
Problem Cause Remedy
Engine fails
to start
1. PTO/Blade Engage knob engaged.
2. Park brake not engaged.
3. Spark plug wire disconnected.
4. Throttle control lever not in correct
starting position.
5. Fuel tank empty, or stale fuel.
6. Blocked fuel line.
7. Faulty spark plug.
8. Engine flooded.
9. Fuse(s) blown.
1. Place knob in disengaged (OFF) position.
2. Engage parking brake.
3. Connect wire to spark plug.
4. Place throttle lever to FAST position.
5. Fill tank with clean, fresh (less than 30 days
old) gasoline.
6. Replace fuel line. See a qualified service dealer.
Replace fuel filter. See the Product Care section.
7. Clean, adjust gap or replace plug.
8. Crank engine with throttle in FAST position.
9. Replace fuse.
Engine
runs erratically
1. Tractor running with choke activated.
2. Spark plug wires loose.
3. Blocked fuel line or stale fuel.
4. Vent in gas cap plugged.
5. Water or dirt in fuel system.
6. Dirty air cleaner.
1. Check that the electric choke is working. See a
qualified service dealer.
2. Connect and tighten spark plug wires.
3. Replace fuel line. See a qualified service dealer. Fill
tank with clean, fresh gasoline and replace fuel filter.
See the Product Care section.
4. Clear vent or replace cap if damaged.
5. Drain fuel tank. Refill with clean, fresh gasoline. See
the Product Care section.
6. Clean or replace air cleaner paper element or clean
foam pre-cleaner.
Loading ...
Loading ...
Loading ...