Loading ...
Loading ...
Loading ...
22
OPERATION
2. Press the REVERSE CAUTION MODE button and hold for 3
seconds. The indicator light will flash for 3 seconds and
will stay on when the REVERSE CAUTION MODE is activated
(Figure 27).
3. The indicator light above the REVERSE CAUTION MODE button
will be ON while activated (Figure 27).
1 2 3
0.5
sec.
3
sec.
STOP
R
Ignition
Key
Indicator
Light
Reverse Caution
Mode Button
Figure 27
4. Once activated (indicator light ON), the tractor can be driven
in reverse with the cutting PTO (blade engage) lever in the
engaged (ON) position.
5. Always look down and behind before and while backing to
make sure no children are around. After resuming forward
motion, press the REVERSE CAUTION MODE button to return
to NORMAL MOWING MODE.
The REVERSE CAUTION MODE will remain activated until:
• The REVERSE CAUTION MODE button is pressed again.
• The ignition key is pressed or removed.
• The operator leaves the seat.
ENGAGING THE PTO BLADE ENGAGE
Electric PTO Tractors
Engaging the PTO (blade engage) transfers power to the cutting
deck or other (separately available) attachments. To engage
the PTO:
1. Move the throttle to the FAST position.
2. Pull the PTO (blade engage) switch outward into the engaged
(ON) position (H in Figure 24 on page 15).
NOTE: When operating the tractor be certain that the throttle is
always in the FAST position. Operating with the throttle at less
than full throttle may lead to premature battery wear and a poor
quality cut.
3. To disengage the PTO (blade engage), push the PTO (blade
engage) switch inward to the disengaged (OFF) position.
Manual PTO Tractors
Engaging the PTO (blade engage) transfers power to the cutting
deck. To engage the PTO:
1. Move the throttle to the FAST position.
2. Push the PTO (blade engage) lever forward into the engaged
(ON) position (Figure 28).
Figure 28
NOTE: When operating the tractor be certain that the throttle is
always in the FAST position. Operating with the throttle at less
than full throttle may lead to premature battery wear and a poor
quality cut.
3. To disengage the PTO (blade engage), push the PTO (blade
engage) lever forward and to the right, out of the locked
position, then release the lever into the disengaged
(OFF) position.
Loading ...
Loading ...
Loading ...