Loading ...
Loading ...
Loading ...
2)Ice-making and its water tank parts
A
B
C
D
E
F
G
H
I
J
Water dividing pipe： with nine little holes, water will flow out from these
little holes. And if no water flows out, can be disassembled and cleaned.
A.Evaporator (ice-making module)
B.Ice full detecting board: Used to check whether the inner cabinet is full
of ice and whether the ice removal process is complete.
C.Water tank：
D.Water supplying pipe：
E.Cover board on the right side of the evaporator：
F.Water level switch installing plate：
G.Water drain pipe of the water tank：When making ice, this pipe should
be stuck in the slot on the wall of the water tank. And when draining, this
pipe should be pulled out.
H.Water pump：
I.Water level detecting switch
TIMER
CLEAN
ON/OF
F
+
-
A
B
C
D
E
3)Operation panel
A．“TIMER CLEAN”button：
setting program; And press this button
for more than 5 seconds, to enter the
Cleaning program.
B. ”ON/OFF”button：When the unit
is off, press this button to turn on the
unit; And during the Self-cleaning
program,
or normal ice-making state, press this
button to turn off the unit at once; And
also if the unit is
set with the Timer, press this button to
cancel the Timer setting. When the
unit is making the ice cube, press this
button for more than 5 seconds, the
unit will switch to ice harvest process
by force.
C. LCD display window
1 2 3 4
5678
1.Ambient temperature display & Ice making time countdown display.
Display the reciprocal of ice making time in unit M, and display the
ambient temperature in unit F.
2.Making ice & Deicing symbol display. The machine is making ice when
the symbol rotates,and the machine is deicing when the symbol flashes.
3.Automatic self-cleaning symbol display.
4.On/off symbol display.
5.Error code display. E1 means the environmental temperature sensor is
damaged.E2 means ice making anomaly or the refrigerant leakage.
6.Water flow in and water shortage display. The arrow flashing indicates
that there is water in the machine; the whole symbol is bright to indicate
that the machine is short of water.
7.Ice full alarm. The machine will make ice again when you take out the
ice.
8.Setting display. Display timing switch machine with H unit; Display ice
making time setting with M unit.
D&E．“-”“+”button：
Used to adjust the duration of the ice making process. The default value
is zero. You can add or subtract one minute each time you press the “+”
or “-” button. You can also adjust the delay time of the timer. The default
value is zero. Press “+” or “-” every time to increase or decrease the
delay time by one hour.
08 09
Loading ...
Loading ...
Loading ...