Loading ...
Loading ...
Loading ...
WARNING
Wear rubber gloves and safety goggles （ and/or face shield）when
handing Ice Machine Cleaner or sanitizer.
WARNING
The ice machine cleaner contains acids.
DO NOT use or mix with any other solvent-based cleaner products.
Use rubber gloves to protect hands. Carefully read the material safety
instructions on the container of the ice machine cleaner.
Use a plastic or stainless container with more than 4 liter/ 0.8 gallon capacity,mix
300ml/10.5oz Nu-Calgon Nickle Safe Ice-machine Cleaner with 2.8 liter/ 0.6
gallon warm water about 120
O
F -140
O
F .Then divide them for 2 shares equally in
2 cups. It is better to keep the temperature of each cup of the cleaning solution.
4.Check to be sure that the water drain pipe of the water tank has been installed
properly in the slot of the tank wall. Then Pour one cup of Nickel-Safe Ice Maker
Cleaning Solution into the water tank. Wait about for 5 minutes.
5.Turn on the power to the ice maker, then press “TIMER CLEAN”button on
control panel for more than 5 seconds, to enter the self-Cleaning program. Same
as above explanation, the water pump runs for 8 minutes and stops for 3
minutes, one cycle, again one cycle. The total duration time is 30 minutes for
one self-cleaning program.
During this process, the “CLEAN”light will always be on during this period, and
the digit window will indicate the remain time.
6.After 30 minutes of one self-cleaning program completing, pull out the drain
pipe of the water tank, drain the cleaning solution down to the lower ice storage
bin. Shake the unit slightly to drain out all of the cleaning solution completely.
Then install back the drain pipe to the slot of the water tank.
7.Repeat steps 4--6 to clean the ice making assembly system again.
4.For the water tank and ice-full detecting plate
Also the water tank and the ice-full
detecting plate is very important to
keep your ice cube hygienic. Put
mixture of neutral cleaner & water
into a clean water jet, then spray to all
the inner surface of tank & the ice
detecting plate. Wipe these surfaces
as far as possible with a clean cloth.
And then, spray the surfaces with
clean water, wiping with a dry clean
cloth. Then drain out the cleaned
water in the water tank by pulling out
the Water drain pipe of the water tank
indicating “H” in above illustration.
When all of the cleaned water has
been drained out, to reinstall back the
water drain pipe of the water tank.
Minerals that are removed from water during
the freezing cycle will eventually form a hard
scaly deposit in the water system. Cleaning the
system regularly helps remove the mineral
scale buildup. How often you need to clean the
system depends upon how hard your water is.
With hard water of 4 to 5 liter (0.8 to 1 gallon),
you may need to clean the system as often as
every 6 months.
1.Turn off the ice maker. Keep the ice maker
connected to the water supply and drainpipe.
But shut off the water faucet of main water
supply.
2.Open the door and scoop out all of the ice
cubes. Either discard them or save them in an
ice chest or cooler.
3.Making the cleaning solution. Please mix the
Nu-Calgon Nickle Safe Ice Machine Cleaner
with water to make the cleaning solution.
Ice-full
detecting plate
Water tank
Suggestion: After cleaning the interior parts and install back to its
respective position, and return machine to work, discard first batch of ice.
Ice Making Assembly System Cleaning by Using Nu-Calgon Nickle Safe
Ice-machine Cleaner
26 27
Loading ...
Loading ...
Loading ...