Loading ...
Loading ...
Loading ...
SIGLENT
8 SDS2000X User Manual
Functional Inspection
1. Press the Default button on the front panel to restore the instrument to its factory
default configuration.
2. Connect the ground alligator clip of the probe to the “Ground Terminal” under the
probe compensation signal output terminal.
Compensation Signal Output Terminal
Ground Terminal
3. Use the probe to connect the input terminal of CH1 of the oscilloscope and the
“Compensation Signal Output Terminal” of the probe.
4. Press the Auto Setup softkey.
5. Observe the waveform on the display. In normal condition, the display should be a
square waveform as shown in the figure below:
Figure 5: Function Inspection
6. Use the same method to test the other channels. If the square waveforms actually
shown do not match that in the figure above, please perform “Probe Compensation”
in the next section.
WARNING
To avoid electric shock during the use of probe, please make certain that the
insulated wire of the probe is in good condition and does not touch the
metallic part of the probe when the probe is connected to high voltage source
Loading ...
Loading ...
Loading ...