Loading ...
Loading ...
Loading ...
SIGLENT
116 SDS2000X User Manual
The threshold you set applies to all channels.
Values greater than the set threshold are high (1) and values less than the set
threshold are low (0).
If the D0~D7 or D8~D15 softkey is set to Custom, press the Custom softkey,
then turn the Universal Knob to select the desired value and push down the
knob to confirm.
To Reposition a Digital Channel
1. Press the Digital button on the front panel to open the DIGITAL function menu and
display the digital channel waveforms.
2. Turn the Ref/Math Waveform Vertical Position Knob to select the channel that you
wish to reposition. The selected waveform is highlighted in red.
3. Turn the Ref/Math Waveform Vertical Variable Knob to move the selected channel
to current position.
To Display Digital Channels as a Bus
Digital channels may be grouped and displayed as a bus, with each value displayed at the
bottom of the display in hex or binary. You can create up two buses.
To configure and display each bus, do the following steps:
1. Press the Digital button on the front panel to open the DIGITAL function menu and
display the digital channel waveforms.
2. Press the Digital Bus softkey to enter the DIGITALBUS function menu.
Figure 63: DIGITALBUS Function Menu
3. Press the Bus Select softkey to select Bus1 or Bus 2.
4. Press the Display softkey to select On to display the bus at the bottom of the display.
Under the DIGITAL function menu, press the Cannel Control softkey, turn the
Universal Knob to select such as DX, and then press the Dx softkey to select On
or Off to set the channel to be included or excluded in the bus.
Under the DIGITAL function menu, press the Channel Group softkey to select
On or Off to include or exclude all digital channels in this group.
Under the DIGITAL function menu, an status indicator is displayed in the status
Loading ...
Loading ...
Loading ...