Loading ...
Loading ...
Loading ...
11
11
The hammer drill is intended for use only in places that have a continuous current rating of ≥ 100 A per phase
and are supplied with a rated voltage of 120V by the distribution network. If necessary, please consult your
electricity supplier to ensure that the continuous current rating of the network is adequate for connecting the
hammer drill at the point where it is connected to the power supply network.
Switching on and off (Fig. E)
Switching on:
•
Press the On/Off switch 2 .
Switching off:
•
Release the On/ Off switch.
Speed adjustment (Fig. F)
•
The speed can be adjusted using the speed regulator
6
according to the requirements. This can be done
when the machine is being operated, with 1 being the lowest and 6 being the highest speed.
LED display
The hammer drill is provided with an LED status indicator at the bottom of the vibration-proof handle
5
.
The two LEDs indicate the following status:
-
If the power cord is inserted, the GREEN LED indicator starts to glow 7 . The hammer drill isready for use
-
If the carbon brushes are qorn out, the RED LED indicator starts to glow
8
. Stop the workand contact the
manufacturer‘s customer service department.
11
Loading ...
Loading ...
Loading ...