Loading ...
Loading ...
Loading ...
10
10
Mounting the depth stop (Fig. D)
•
Press and hold the depth stop locking latch 1 2
on the additional handle 9
•
Insert the depth stop 15 into the hexagonal opening provided on the additional handle above the locking
latch.
•
Push the depth stop in the direction of the hammer drill till the desired depth is reached.
•
Release the locking latch of the depth stop.
•
Check the locking mechanism by gently pulling the inserted depth stop.
•
To readjust the depth stop or to remove it,proceed in same order.
4.
Usage
Mains connection
The hammer drill is designed for use with single- phase AC 120 V
~
/
60 Hz and has protective
insulation. Check whether the mains voltage of
the socket corresponds with the mains voltage indicated on the drill’s rating label. Use an extension cable if the
work area is not close to the mains outlet. Ensure an extension cable with sufficient conductor diameter (min.
1.5 mm²) is used. If necessary, ask the dealer for advice when purchasing. The extension cable used should be as
short as possible. Ensure the mains cable does not pose a tripping hazard.
Mains cables may only be replaced by the manufacturer, an authorised service centre or a qualified person.
Loading ...
Loading ...
Loading ...