Loading ...
Loading ...
Loading ...
EN - 18
Cleaning and maintenance
• The machine will proceed with pulse
dispensing to clean the dispensing unit (21)
. Overall, the operation takes approx. 10
minutes. The button (14) ashes indicating
that the procedure is in progress.
• At the end of the procedure all the keys will
light up with a xed light and the machine
will emit a double sound, if the acoustic
signals are active.
• Remove the lter-holder (20) and check that
the detergent has dissolved completely. If
this is not the case, repeat the operation.
• At the end, remove the lter-holder (20) and
the cleaning disk (32) inside.
• Before dispensing a coffee beverage,
attach the lter-holder (20) again with the
lter (31b) to the dispensing unit (21) and
press the button (14) to rinse the circuit.
6.4 Descaling (Fig.B-N)
Before performing the descaling
cycle, remove any water softener
lters present inside the tank (7).
Stay near the machine for the entire
duration of the descaling cycle
since you may be required to ll
the tank, for example.
The entire descaling and rinsing
cycle lasts approximately 40
minutes.
The coffee machine signals when it is
necessary to carry out a descaling cycle on
the basis of the water hardness set (For setting
of the water hardness, see the “Setting water
hardness” paragraph). If the button (14) lights
up with a xed orange light, it means that
a descaling cycle is necessary, so as not to
alter the taste of the coffee and damage the
machine. However, coffee, steam/hot water
can continue to be dispensed.
Proceed as follows to perform the descaling
cycle:
• Remove the lter-holder (20) from its seat
• Place a container with a capacity of at least
500 ml under the dispensing unit (21) and
another with a capacity of at least 800 ml
under the steam wand (22).
• Fill the tank (7) up to “MAX” with a solution
of water and descaler following the doses
recommended by the manufacturer.
• Press keys (11) and (14) simultaneously for
5 seconds to enter the programming menu.
• Turn the lever (15) anti-clockwise to the
steam intensity position.
• Buttons (11), (12) and (13) switch off, while
the button (14) ashes with an orange light.
• Press (14) to start the descaling cycle.
During the descaling cycle, the
machine will make a few pauses to
allow the descaler to act effectively
Wait for the end of the cycle.
• The descaling cycle ends when the button
(14) turns white.
• Remove the tank (7) and rinse it under
running water to remove any traces of
descaler.
Loading ...
Loading ...
Loading ...