Loading ...
Loading ...
Loading ...
EN - 13
EN
To reset the manufacturer's original
settings, press the keys at the same
time for at least 10 seconds. All of
the keys ash at the same time and
the machine emits a single sound
indicating that factory settings have
been reset.
5 Machine settings
The programming menu can be used to set:
- Auto power-off time (Stand-by)
- Water hardness
- Coffee temperature
- Pre-brewing proles
To access the programming menu, press keys
(11) and (14) at the same time for 5 seconds.
All of the keys ash simultaneously.
• To make the settings relative to the auto
power-off times, press the key (11).
• To set the level of water hardness, press the
key (12).
• Press key (13) to set the extraction
temperature.
• To set the desired pre-brewing times, press
the key (14).
Auto power-off time
After approx. 5 minutes of no use, the machine
goes into Eco mode.
Proceed as follows to change this setting:
• Access the programming menu as indicated
previously.
• Press the key (11), it will ash 3 times to
indicate selection.
• The current setting is shown with the keys
switching on, as shown in the following
table:
Key
Auto power-off time
set
11 Eco Mode (10 minutes)
11.12 30 minutes
11,12,13 40 minutes
11,12,13.14 60 minutes
• Press the key corresponding to the desired
setting to modify the time, as indicated in
the table.
Key
Auto power-off time to be
set
11 Eco Mode (10 minutes)
12 30 minutes
13 40 minutes
14 60 minutes
• The key selected will ash 3 times and a
sound will be emitted (if the acoustic signals
are active) to indicate the setting has been
saved.
Water hardness
The machine is factory set to “Very Hard Water
Level”. The machine can be set according to
the actual hardness of the water used, thus
making the requirement for descaling less
frequent.
If you don’t know the water hardness, use
the test strip supplied (17) and follow the
instructions below:
• Remove the reactive strip supplied (17) from
its packaging.
Use
Loading ...
Loading ...
Loading ...