Loading ...
Loading ...
Loading ...
5WWW.SENIXTOOLS.COM
4. DO NOT expose tools to rain or wet
conditions or use electric tools in
wet or damp locations. Water entering
an electric tool will increase the risk of
electric shock.
5. If operating an electric tool in damp
locations is unavoidable, ALWAYS USE
a Ground Fault Circuit Interrupter to
supply power to your tool. ALWAYS
WEAR electrician’s rubber gloves and
footwear in damp conditions.
6. To reduce the risk of electric shock,
use only with an extension cord intended
for outdoor use, such as an extension
cord of cord type: SW-A, SOW-A, STW-A,
STOW-A, SJW-A, SJOW-A, SJTW-A. or
SJTOW-A.
7. INSPECT tool cords for damage. Have
damaged tool cords repaired at an
authorized Service Center. BE SURE to
stay constantly aware of the cord location
and keep it well away from the cutting
blade.
8. DO NOT abuse the extension cord.
NEVER use the cord to carry the tool by
or to pull the plug from the outlet. Keep
cord away from heat, oil, sharp edges or
moving parts. Replace damaged cords
immediately. Damaged cords increase the
risk of electric shock.
EXTENSION CORDS
Use a proper extension cord. ONLY use
cords listed by underwriters Laboratories
(UL). Other extension cords can cause a drop
in line voltage, resulting in a lo--ss of power
and overheating of tool.
For this tool an AWG (American Wire Gauge)
size of a least 14-gauge is recommended for
an extension cord of 25-ft. or less in length.
Use 12-gauge for an extension cord of 50-
ft. Extension cords 100-ft. or longer are not
recommended.
Remember, a smaller wire gauge size has
greater capacity than a larger number
(14-gauge wire has more capacity than
16-gauge wire; 12-gauge wire has more
capacity than 14-gauge). When in doubt use
the smaller number.
EXTENSION CORDS
Ampere Rating
Securing extension cord
Volts Total length of cord in feet
More than/Not more than AWG
120 V 25 50 100 150
0-6
6-10
10-12
18
18
16
16
16
16
16
14
14
14
12
12
12-16 14 12 Not recommended
GENERAL POWER TOOL SAFETY
WARNINGS
Keep the extension cord clear of the work
area. Position the cord so that it will not
get caught on bushes, hedges, tree trunks,
lawnmowers or other obstructions while
you are working with the Chain Saw.
Check extension cords before each use. If
damaged replace immediately. Never use
tool with a damaged cord since touching
the damaged area could cause electrical
shock, resulting in serious injury.
Read all safety warnings and all instructions.
Failure to follow the warnings and instructions
mayresultinelectricshock,reand/or
serious injury.
Save all warnings and instructions for future
reference. The term “power tool” in the
warnings refers to your mains-operated
(corded) power tool or battery-operated
(cordless) power tool.
CAUTION:
WARNING:
WARNING:
Loading ...
Loading ...
Loading ...