Senix CSE12-M Operator’s manual

Loading ...

13WWW.SENIXTOOLS.COM

1. In order to ensure safe work, DO NOT

operate the saw above shoulder height.

2.Positionthecordsothatitwillnotbe

caught on branches and the like, during

cutting.

3. Never stand below a branch that is being

sawed.

4. Exercise caution when sawing both

branches under tension or branches that

are splintering.

5. Make sure to safe guard against the risk of

injuryfromfallingbranchesandyingwood

projectiles.

6. If the machine is in operation, keep persons

OPERATION

PREPARATION

PREVENTING KICKBACK

ON/OFF SWITCH

SAFETY WARNINGS

WARNING!

CHAIN SAW: Beforebeginningwork,inspect

the chain saw for damage to the housing,

the extension cord, the saw chain and the

chain bar. Never use an obviously damaged

machine.

OIL TANK:Checkthellleveloftheoiltank.

Alsocheckwhetherthereissufcientoil

available while working. Never operate

the saw if there is no oil or the oil level has

dropped below the minimum oil level mark

in order to prevent damage to the chain

saw.Onaverage,anoilllingissufcientfor

approximately 10 minutes of cutting operation

(depending the duration of pauses and the

density of the work piece).

SAW CHAIN: Check the tension of the

saw and the condition of the blades. The

sharper the saw chain is, the easier and more

manageable operations will be. The same

applies to chain tension. Check the tension

every 10 minutes of operation to maximize

safety. New saw chains in particular are

subject to changes due to the heat created by

operation.

PROTECTIVE CLOTHING: Make absolutely

suretoweartheappropriateclose-tting

protective clothing such as protective pants,

gloves and safety shoes. Wear a safety

helmet with integrated hearing protection and

a face guard to provide protection against

falling and recoiling branches.

DO NOT cut down trees in high wind

conditions. This can result in injury and

should only be performed by a trained

professional.

Beforeeachuse,checkthefollowingitemsto

ensure safe working conditions.

The term kickback refers to when the saw

suddenly jumps up and back. This is usually

caused by the work piece coming into contact

with the chain bar tip or the clamping of the

saw chain.

A kickback generates an abrupt powerful

force. The saw usually reacts in an

uncontrolled manner, creating the possibility

of injury to the user.

The danger of a kickback is greatest when

attempting to cut near or with the chain

bartip.Alwaysapplythesawasatlyas

possible in order avoid a loss of control during

operation.

To turn the tool ON: press the safety button

and then squeeze the trigger (Fig. 6). After

the tool has started, you can release the

safety switch without turning the tool off.

To turn the tool OFF: release the trigger

switch (Fig. 6).

and animals away from the danger area.

7 The machine is not protected against

electric shock when coming into contact

with high-voltage lines. Maintain a minimum

clearance of 30 feet from current-carrying

power lines to avoid life-threatening electric

shock.

8. When working on an incline, always stand

above or to the side of the branch being

sawed.

9. Allow the chain to cut for you. Keep the

saw running at full speed for the entire

duration of the cut.First-time user should,

as a minimum practice, cutting logs on a

saw-horse or cradle.

Loading ...

Senix CSE12-M 16-inch 12 Amp Corded Electric Chainsaw

Operator’s manual - Page 13