Loading ...
Loading ...
Loading ...
Installation Instructions
230/208 VOLT ELECTRICAL SUPPLY
HOW TO CONNECT
1Remove the reran cabinet.
2Connect to electrical power.
3See the special instructions below fin" applicable
supply voltages.
4 Reinstall the room cabinet.
A power supply kit must be used to supply power to fl_e
Zoneline trait. The apl)ropfiate kit is detemfined by the
voltage, the means of electrical connection and the
amperage of the branch circuit.
Power supply kit
C(mnecfions of 208 or 230 volt circuits may be with a
power SUl)pl ) kit or a jtmction box kit.
All wiring, including installation of tile receptacle,
must be in accordance with the NEC and local codes,
ordinances and regulations. I,ocal codes may require
the use of an arc tault or leakage current detection
device on the power cord. Be stu'e to select the
correct cord fin" wmr installation.
© © @
Tandem Perpendicular Large Tandem
15Amp. 20Amp. 30Amp.
230/208volt receptacle configuration.
Branch Circuit and Proper GEPower Cord
UnitAmperage Bating with LCDIDevice
15 RA1(3153
20 1_I(24203
30 ],L&K3303*
':Not approxed tor use on 7000 BTU models.
Power cords may include an arc fault interruption or
a leakage current detection interruption device. A
test mad reset button is provided on the plug case or
the inline case. The device should be tested on a
periodic basis by first pressing the TEST button and
then the RESET button. If the TEST button does
not trip or if the RESET button will not stay engaged,
discontinue use of the Zonelhae and contact a
qualified service technician.
Order Kit RAK4002B for 230/208 xolt direct I
I
I
COllllectioll.
IF USING AN ELECTRICAL
SUBBASE
230/208 xolt models ma) be installed using one of
the fi)llowing electrical subbases:
Branch Circuit and Proper GE
UnitAmperage Bating Subbase Kit
15 ]L_IL204D 15P
20 ]L_IL204D20P
30 RAIZ,204D30 P *
*Not approved {i)r use ou, 7000 BTU models.
Electrical subbases provide an enclosm'e tot direct
cmmection or enclosed receptacles. The subbase kit
includes the power cord.
The instructions provided with the selected subbase kit
must be carefifllv tollowed. It is the responsibility of the
installer to ensm'e tile connection of components is
done in accordance with these instructions and all
electrical codes.
14
Loading ...
Loading ...
Loading ...