Loading ...
Loading ...
Loading ...
19
rests on or the surrounding area. To remove the drip tray, pro-
ceed as follows:
1. Remove the drip tray and coee grounds container (A10)
(g. 28);
2. Check the red condensate tray (A11) and empty if full;
3. Remove the cup tray (A12) and drip tray grille (A13), then
empty the drip tray and grounds container and wash all
components;
4. Put the drip tray complete with grille and grounds contain-
er back in the appliance.
Important!
When removing the drip tray, the grounds container must be
emptied, even if it contains few grounds. If this is not done,
when you make the next coees, the grounds container will ll
up more than expected and clog the machine.
15.5 Cleaning the inside of the machine
Danger of electric shock!
Before cleaning internal parts, the machine must be turned o
(see section “5. Turning the appliance o”) and unplugged from
the mains power supply. Never immerse the machine in water.
1. Check regularly (about once a month) that the inside of the
appliance (accessible after removing the drip tray (A14))
is not dirty. If necessary, remove coee deposits with the
brush (D5) supplied and a sponge.
2. Remove all residues with a vacuum cleaner (g. 30).
30
15.6 Cleaning the water tank
Clean the water tank periodically (about once a month) and
whenever the softener lter (D4) in the water tank (A22) is
replaced.
1. Take out the water tank (g. 2), remove the water softener
lter (if installed) and rinse with running water;
2. Empty the water tank and clean with hot water, if nec-
essary with the aid of a clean, non-abrasive cloth. Rinse
thoroughly with water;
3. Reinstate the lter (g. 31), ll the tank with fresh potable
water up to the MAX level (g. 3) and reposition the tank
in the machine;
31
4. (models with water softener lter only) — deliver 100ml of
hot water to reactivate the lter.
Please note:
If the appliance is not used for more than 3-4 days, you should
clean the tank as described above.
15.7 Cleaning the coee spouts
1. Clean the coee spouts (A7) regularly with a sponge or
cloth (g. 32);
32 33
2. Check the holes in the coee spouts are not blocked. If nec-
essary, remove coee deposits with a toothpick (g. 33).
15.8 Cleaning the pre-ground coee funnel
Clean the pre-ground coee funnel (A4) regularly (about once a
month) with a damp cloth. Proceed as follows:
1. Turn the machine o (see chapter “5. Turning the appliance
o”;
2. Open the funnel ap;
3. Clean the funnel with the brush provided (D5);
4. Close the ap.
Important!
After cleaning, make sure there are no accessories left in the
funnel. The presence of foreign objects in the funnel while the
machine is in operation could damage the appliance.
15.9 Cleaning the brewing unit
The brewing unit (A6) must be cleaned at least once a month.
Important!
The brewing unit cannot be extracted while the machine is on.
Loading ...
Loading ...
Loading ...