Loading ...
Loading ...
Loading ...
Putting the RS 5200 into operation
RS 5200 | 17
To indicate that the operating time is decreasing, each LED segment
slowly dims before it goes off completely.
If the actual operating time differs widely from the specified values,
the rechargeable battery is probably exhausted and should be
replaced. Information on the rechargeable battery: see page 29.
Using the charging reminder functionn
When the stethoset receiver is switched off and the transmitter
automatically switches off (standby mode), the
Battery
LED will
flash back and forth for 10 minutes to remind you to charge the ste-
thoset receiver.
▷ Charge the stethoset receiver by placing it into the transmitter’s
charging compartment (see page 15).
The LED stops flashing and the charging process starts.
Battery LED Meaning
Battery
LED
flashes slowly
Rechargeable battery
is empty; recharge the
rechargeable battery
1
st
LED segment
lit
approx. 4 hours of
operating time
1
st
+ 2
nd
LED
segment lit
approx. 8 hours of
operating time
All LED
segments lit
approx. 12 hours of
operating time
The display of the remaining operating time can be set so that
it automatically switches off after 30 seconds (see page 32).
If more than one stethoset receiver is connected to the trans-
mitter, the remaining operating time/charge status cannot be
displayed.
You can also switch off the charging reminder function (see
page 32).
Loading ...
Loading ...
Loading ...