Loading ...
Loading ...
Loading ...
26
bromic.com/heat
WARNING: MUST ONLY BE SERVICED BY LICENSED &
AUTHORIZED TECHNICIAN.
1. Locate the small black button on the small LED PCB
(shown in image on right), and the small button wid way
down the back face of the remote (for later steps).
2. Switch the power supply to the Eclipse Portable
Control ON.
3. Using a thin item (e.g. paper clip/needle),
SHORT PRESS the small button on the rear of the remote.
Within 5 seconds of pressing the small button on the rear
of the remote, press the small black button on the LED
PCB 3 times, holding the button down on the third press.
(2X SHORT PRESS followed by 1X PRESS & HOLD)
While the LED PCB button is held down, SHORT PRESS
the Lights 100% button on the remote control.
4. The LED on the Heater head will flash 3 times to
indicate the remote is paired.
5. Refit the lid to the Portable Control Box, using the 6x
Oval head screws (#4-40 - Length: 1/2”).
6. Refit the Portable Control Box Cover using 4x M4x8mm
Dome Head Phillips screws.
7. Replace the two weights onto the Portable Control
Box Cover, and rotate the Base Top Cover to the correct
position on the Base.
8. Replace the 1x M4x6mm Dome Head Screw into the
rear of the Base Top Cover.
Lights 100% (DIM˄)
Lights OFF (DIM˅)
DANGER
ELECTRICAL SHOCK HAZARD! Serious injury or
death may occur. Do not touch any components
other than specified below. Protective equiment
including insulated gloves must be worn.
!
PAIRING REMOTE CONTROL TO LED PCB (BOTTOM 3 BUTTONS OF REMOTE)
1s (short)
Remote Reset button
1 2 3(hold)
1s (short)
OPERATING INSTRUCTIONS
Loading ...
Loading ...