Loading ...
Loading ...
Loading ...
24
bromic.com/heat
OPERATING INSTRUCTIONS
REMOTE CONTROL BATTERY
• CAUTION: Do not ingest battery—Chemical burn hazard.
• The remote control supplied with this product contains a coin/button cell battery. If the coin/button cell
battery is swallowed, it can cause severe internal burns in just 2 hours and can lead to death.
• Keep new and used batteries away from children.
• If the battery compartment does not close securely, stop using the product and keep it away from
children.
• If you think batteries might have been swallowed or placed inside any part of the body, seek immediate
medical attention and call a doctor.
• Explosion hazard if the battery is substituted incorrectly.
• Replace the battery with a CR2430 type battery only.
• Battery is not rechargable and must not be recharged.
• Always wrap the battery up, both when it is being stored and when it is being disposed of. The battery
should not come into contact with other metal objects as it could cause the battery to run down, catch fire
or be damaged.
• Dispose of damaged or finished batteries immediately in compliance with the law. To this end, contact the
authorities for safeguarding the environment or the centre for disposing of waste materials in your area.
• Do not throw the battery away with household rubbish.
• The supply terminals are not to be short-circuited.
• Battery must be inserted with correct polarity (+/-)!
To replace the battery:
1. Remove screw and open the back cover of the remote.
2. Take the old battery out and put the new one in the same way.
PREPARING TO MOVE THE APPLIANCE
1. Unplug the supply lead of the appliance from the wall outlet.
2. Remove 1x M4x6mm Screw from Base Top Cover, and rotate the Base Top Cover to expose the Base
weights and any floor fastening bolts.
3. Remove any floor fastening bolts from inside the base.
4. Ensure a clear path is available from where the appliance is located and where it is to be moved to.
MOVING THE APPLIANCE
1. Positioned behind the appliance, and using two
hands on the arm, tilt the appliance forwards
slightly until it is resting on the two front wheels on
the underside of the base.
2. Roll the appliance forwards to the desired location.
3. If required, pivot the appliance on the two wheels,
whilst monitoring the position of the head to prevent
accidental collisions.
4. Replace any floor fastening bolts back into the base
and floor if applicable.
IMPORTANT
If any weights need to be removed to access floor fastening bolts, DO NOT remove more than 3
weights at any one time, and replace all weights prior to moving the appliance.
WARNING
Heater is heavy and can cause crushing injury.
DO NOT place feet under base whilst moving the
heater. Ensure adequate protective clothing is
worn to protect user from injury (i.e. appropriate
protective footware).
!
!
Loading ...
Loading ...
Loading ...