Loading ...
f i FULLONE YEAR WARRAN ON CRAFTSMAN STATUONARY TOOL
B_ _!: if this stationa_:tool fails due to a_defect in material or workmanship within one year from the date
I!ii!iof pUrChase;:C()NTACT THE NEAREST SEARS SERVICE CENTER IN THE UNITED STATES and
I:_Sears will repair it free of charge.
Iill This Warranty applies only while this product is in the United States.
I_iil; If this sander!s used for commercial or rental purposes, this warranty will apply for ninety days
_ii: from the dateof purchase.
Iiii::This warranty gives you specific legal rights, and you may also have other rights which vary from
i!ii_ state to state.
Sears, Roebuck and Co., D/817 WA Hoffman Estates, IL. 60179
Safety instructions For Belt and Disc Sander ........
Safety is a combination of common sense, staying alert
andknowing how your belt and disc sander works. Read
this manual to understand this sander.
Safety Signal Words
DANGER: means ifthe safety information is not followed
someone will be seriously injured or killed.
WARNING: means if the safety intormation is not fol-
lowed someone could be seriously injured or killed.
CAUTION: means if the safety information is not followed
someone may be injured.
Before Using the Sander
IWARNING: To avoid that cause
mistakes could
serious, permanent injury, do not plug the sander
in until thefollowing steps are completed,
•Completely assemble sander. See "Assembly"section.
- Learn the use and:function of the ON-OFF switch. See
"Getting to Know:You r Sander"section.
• Review and understanding of all safety instructions
and operating procedures in this manual.
- Review of the maintenance methods for this sander.
See "Maintenance" section.
Read the following WARNING label found on the front of
the sander:
When Installing Or Moving the Sander
Avoid dangerous environment. Use the sander in a
dry, indoor place protected from rain. Keep work area
well lighted.
Place the sander so neither the user or bystanders are
forced to stand in line with the abrasive belt or disc.
To avoid burns or other tire damage, never use the
sander near flammable liquids, vapors or gasses.
To avoid injury or death from electrical shock:
• Ground the sander. This sander has an approved 3-
conductor cord and a 3-prong grounding type plug.
Use only 3-wire, grounded outlets rated 120 volts, 15
amperes (amps)_ The green conductor in the cord is
the grounding wire. To avoid electrocution, never con-
nect the green wire to a live terminal
Make sure your fingers do not touch the plug's metal
prongs when plugging or unplugging the sander,
Never use this or any power sander for wet sanding.
Doing so could cause electrocution, serious injury or
worse.
To avoid injury from unexpected sander movement:
•Always unplug the sander before moving it.
• Put the sander on a firm level surface where there is
plenty of room for handling and properly supporting the
workpiece.
•Support the sander so it does not rock.
•Bolt the sander to its work surface, Use the fasteners
and method shown in "Assembly" section.
• Never stand on tool. Serious injury could occur if the
tool tips. Do not store anything above or near the too!
where anyone might stand on the tool to reach it,
To Avoid Back Injury
•Get help or use recommended casters when you need
to move the sander
• Always get help if you need to liftthe sander.
•• •, i i¸.... i¸¸
Loading ...
Loading ...
Loading ...