Loading ...
Loading ...
Loading ...
to Know Your Belt and: Disc Sander (continued)
4. Backstop:Lock scre_w.Locks the backstop in place, tt
is:iocked using:the ii/2, wrench:Supplied: BACKSTOP
LOCKSCREW
\\
BACKSTOP
5. Belt Table Locking Bolts. Lock the belt table in posi-
tion.
To adjust to vertical position:
a. Remove the backstop.
b. Loosen the two belt table locking bolts using the
1/2" wrench, supplied with your machine.
c. Position belt table vertically and tighten the two
bolts:
6. AbrasiveBeit Table Stop. Can be adjusted so that
the abrasive belt table is level when in a horizontal
position:.
a. Loosen the lock nut using a 3/4'! wrench.
b.Place a level on tl_e abrasive belt table and using
a 3/4" wrench, screw the stop bolt in orout until the
table is level,
BELT TABLE
LOCKING
LOCK NUT
STOP BOLT
Safety Instructions for Belt and Disc Sander
Before Using the Sander:
IWARNING: To avoid mistakes that could cause !
serious, permanent injury, do not plug the sander
in until the following steps are completed.
•Completely assemble the sander. See "Assembly" section.
•Learn the use and function of the ON-OFF switch. See
"Getting to Know Your Belt and Disc Sander" section.
° Review and understanding of all safety instructions
and operating procedures in this manual.
•Review of the maintenance methods for this sander.
See "Maintenance" section.
When Installing Or Moving the Sander:
Avoid dangerous environment. Use the sander in a dry,
indoor place protectedfrom rain. Keep work area well lighted.
Place the sander so neither the user or bystanders are
forced to stand in line with the abrasive belt or disc.
To avoid burns or other fire damage, never use the
sander near flammable liquids, vapors or gasses.
To avoid injury or death from electrical shock:
'GrOund the sander. This sander has an approved 3-
conductor cord and a 3-prong grounding type plug.
Use only 3-wire, grounded outlets rated 120 volts, 15
amperes (amps). The green conductor in the cord is
the grounding wire. To avoid electrocution, Never con-
nect the green wire to a live terminal.
° Make sure your fingers do not touch the plug's metal
prongs when plugging or unplugging the sander.
o Never use this or any power sander for wet sanding. Doing
so could cause electrocution, serious injury or worse.
To avoid injury from unexpected sander movement:
°Always unplug the sander before moving it.
• Put the sander on a firm level surface where there is
plenty of room for handling and properly supporting
the workpiece.
oSupport the sander so it does not rock.
o Bolt the sander to its work surface. Use the fasteners
and method shown in "Assembly" section,
•Never stand on tool, Serious injury could occur if the
tool tips. Do not store anything above or near the tool
where anyone might stand on the tool to reach them.
18
Loading ...
Loading ...
Loading ...