Loading ...
Loading ...
Loading ...
7, If the abrasive belt moves to the right:
a. Turn the belt adjustment knob clockwise slightly,
until the belt recenters itself.
b. The abrasive belt is tracking properly when it is
centered on the drive pulley.
8. If the abrasive belt moves to the left:
a. Turn the belt adjustment knob counterclockwise
slightly until the belt recenters itself,
b. The abrasive belt is tracking properly when it is
centered on the drive pulley.
9, Turn machine on and off several times to observe
tracking. Repeat steps 7 and 8 as needed.
10. Turn machine on and adjust tracking, if needed, by
turning the belt adjusting knob slightly.
ABRASIVE
DISC
PUSH BELT IN
DIRECTION OF DISC
BELT
DRIVE MOVING
PULLEY TO RIGHT
BELT ADJUSTING
KNOB RIGHT
LEFT
installing Belt Dust Trap
1. Find one 10-32 x 9/16" pan head screw and a lock-
washer among the loose parts.
2. Attach the dust trap. Make sure the top edge is below
the surface of the abrasive belt.
i i i ii iiii iiiiiiiiiii
Installing Backstop
1. Find one 5/16 x 1" hex head bolt and one flat washer
among the loose parts,
2. Place the washer on the bolt, and screw it halfway
into the mounting hole. Place the backstop into posi-
tion and tighten the bolt. When removing the back-
stop, loosen the bolt but do not remove it.
PAN HEAD SCREW
AND LOCKWASHER BELT DUST TRAP
BACKSTOP
LOCK SCREW BACKSTOP
15
Loading ...
Loading ...
Loading ...