Loading ...
Loading ...
Loading ...
ASSembly (continued)
Installing WorkTable
NoTE_:Appiyl aCoatof paste iwax to:the work table: This
wiii:make _iia :little easier to feed the wotk_
:;t_ Loosen thetabl'e positioning screw.
21Insert the table :support rod:in the hole in the ba:se
untilthe edge of ti_etable is approximately 1/i6" from
the abrasive disC: Tighten the screw.
NOTE:There is a second mounting hole in the base. This
is for mounting tl_e:tabie When the belt is used in a verti-
cal position,
WARNING: To avoid trapping the work on fingers
between the table and sanding surface, the table
edge should be a maximum 1116 inch from the
sanding surface, the table should be completely
engaged on the rod.
ABRASIVE
DISC
WORK
TABLE
/
/
SECOND
MOUNTING
HOLE TABLE
J SUPPORT
TABLE ROD
POSiTiONING
SCREW
, i p,i ,,
Installing the Abrasive Belt -
Tensioning andTrack!ng
IWARNING: To avoid Injury from accidental start,
turn, switch _OFF_,: remove key!:and remove plug
from power sour€el outlet before removing or
installing abrasive belt_
NOTE: Two types of belts may be used,
On the smooth side of the abrasive belt you will see a
!'direCtional arrow."
Lap Splice: The abrasive belt must run in direction of this
arrow so that the splice does not come apart:
Butt Splice: The arrow points in both directions or identi-
fies no arrows, this indicates the user may position the
belt in either direction.
1:::Pdsh tension |eVerto rear position:
2. Turn bett adjustment knob counterclockwise.
3. Appty light pressure to the idler pulley so the pulley
moves to rigfit_ :_:
4. Place the abrasive belt over the idler and drive pul-
leys with the-directional arrow pointing as shown.
Make sure the abrasive belt is centered on both pul_
teys.
5. Position tension lever in forward position. When the
idler pulley is moved outward, it puts tension on the
belt.
6. Standing to the side of the machine, push the belt by
hand to check if belt is moving either left or right.
DIRECTIONAL ARROW
ABRASIVE BELT
DRIVE
IDLER PULLEY
BELT ADJUS_tENT
KNOB
IN REAR
POSITION
.EVER
14
Loading ...
Loading ...
Loading ...