Loading ...
Loading ...
Loading ...
3 Now use the corresponding LCD soft control knobs to set the correct IP address for
your switcher.
4 Press the ‘save changes’ soft button to confirm the setting.
Your panel will now connect with your switcher.
On the ATEM Advanced Panel, press the ‘network’ LCD soft button to
open the network settings on the LCD, then use the system control
arrow buttons to navigate to the switcher IP address setting. Use the
soft controls to set the network IP address for your switcher, and don’t
forget to save the changes.
NOTE Changing the switcher IP address on your panel does not change the
IP address of the switcher itself. It just changes where the control panel is looking to
find the switcher. If the control panel cannot find the switcher, then you might need
to check the switcher to see if it’s been set correctly. To change the IP address of
the switcher, connect the switcher via USB to a computer and run ATEM Setup as
described previously in this manual.
Changing the Hardware Panel Network Settings
Because the hardware panel is also on the network and communicating with the switcher,
italso has network settings so it can connect to the network. These settings are different to
theswitcher IP address, which is just where the panel is looking to find the switcher. The panel
network settings can be changed by following the steps below:
64Using ATEM Hardware Panels
Loading ...
Loading ...
Loading ...