Loading ...
Loading ...
Loading ...
ASSE
HOW TO SET UP YOUR TRACTOR
PREPARE BATTERY (See Fig. 2)
CAUTION: Wear eye and face shield.
Wash hands or clothing immediately if
accidentally in contact with battery acid,
Do not smoke. Fumes from charged
battery acid are explosive.
Read the instructions included with the
batteryvent caps. Alwayswear gtoves,
clothing and goggles to protect your
hands, skin and eyes.
LY
INSTALL SEAT (See Fig. 3)
Adjust se£_ before tightening adjustment bolt,
• Remove cardboard packing on seat pan.
, Place seat on pan and assemble shoulder bolt,
• Assemble adjustment knob loosely, Do not tighten,
• Tighten shoulder bolt securely.
o Lower seat into operating position and sit on seat.
• Slide seat until a comfortable position is reached
which allows you to press clutch/brake pedal all the
way down (See Fig. 6).
, Get off seat without moving its adjusted position.
• Raise seat and tighten adjustment knob securely,
Your unit has a battery charging system which is sufficient
: for normal use. However, periodic charging ofthe battery
: with an automotive charger will extend its life.
, See instructions packed with vent caps in parts bag.
o Fill battery with acid. Fill each cell until it reaches the
bottom of the vent wells. Do not overfill.
Allow battery to stand and settle for at least thirty
minutes. After standing, check the level of acid. If
below the vent wells, add more acid until the correct
level is reached.
While battery is standing (after adding acid) and later, while
battery is being charged, continue with assembly of unit.
, To maximize the life of your battery, it is necessary that
the battery be charged before use. Use a 12 volt battery
charger. Charge battery at a rate of 6 amperes for !
hour. Observe all safety precautions required for bat-
tery charging. FaiIure to charge battery can result in a
shortened battery life.
o Check the acid level after the battery is charged, tf the
acid has fallen below the correct level, add distilled or
iron free water.
o Install the vent caps to cover the vent wells. Wash the
top of the battery with water to remove any acid, then
wipe dry.
, Check battery case for leakage to make sure that no
damage has occurred in handling.
• Dispose of excess battery acid. Neutralize acidfordis-
posaf by adding itto four inches of water in a five gallon
plastic container. Stir with a wooden or plastic paddle
while adding baking soda until the addition of more
soda causes no more foaming.
• Follow instructions on how to install battery.
CUT AWAY VIEW
VENT CAP
BATTERY
CELL ACID
LEVEL
SEAT
SEAT PAN
SHOULDER
BOLT
ADJUSTMENT
KNOB
FLAT WASHER
FIG, 3
CHECK T_RE PRESSURE
The tires on your unit were overinflated at the factory for
shipping purposes. Correct tire pressure is important for
best cutting performance.
, Reduce tire pressure to PSt shown in "PRODUCT
SPECIFICATIONS" on page 3 ofth s manual.
CHECK DECK LEVELNESS
For best cutting r:esults, mower housing should be properly
leveled: See TO LEVEL MOWER HOUSING" in the
Service and Adjustments section of this manual.
CHECK FOR PROPER POSITION OF ALL
BELTS
See the figures that are shown for repiacing motion and
mower blade drive belts in the S_rvice and Adjustments
section of this manuaf. Verify that the belts are routed
correctly.
CHECK BRAKESYSTEM
After you learn how to operate your tractor, check to see
that the brake is properly adjusted. See "TO ADJUST
BRAKE" in the Service and Adjustments section of this
manual.
FIG. 2 8
Loading ...
Loading ...
Loading ...