Loading ...
Loading ...
Loading ...
8
CONTROLS AND SETTINGS
Press START and close the door
immediately (within 4 seconds). A
tone indicating that countdown has
started sounds while the Close Door
LEDs blink. The selected cycle starts
when the countdown is completed.
If the cycle was not yet started, to
cancel a delay time press the delay
button until the time returns to zero.
If the cycle has started pressing the
CANCEL button will reset both the
cycle and the delay options.
When a time delay is set for an
hour or more and the wash hasn’t
started, the remaining delay time
counts down on the display in full
hour increments.
When the delay time is less than
1h, the remaining delay time counts
down in hour and min (0:59), and
the delay LED is illuminated during
the delay countdown.
4
Status Window
The status window indicates the
number of delay start hours, the
number of minutes left in a cycle,
the level of rinse aid dosage, and
the cycle prompts.
5
Start
The LEDs of the selected cycle and
options are illuminated when the
cycle and options are selected. The
status window displays the cycle
time and the START LED blinks.
Press START and close the
dishwasher door immediately
(within 4 seconds) to start the
cycle.
Once the START button is pressed
the corresponding LED stops
blinking and stays on. The CLOSE
LED blinks and a reminder tone
sounds every 30 seconds until
START or CANCEL is pressed
or if the door is closed without
pressing start. The tone will sound
a maximum of 5 times.
The blue floor indicator light
illuminates to indicate the washer is
running. During the cycle, buttons
are disabled, displaying the cycle
and options selected, and the time
left for the wash is displayed on the
status window.
If a cycle is paused the floor
indicator Light stays ON until the
door is opened.
6
Cancel
Both a running cycle and a delay
countdown can be canceled at any
time. Open the dishwasher door
and press Cancel. A tone will sound
indicating that the cycle has been
successfully canceled.
If desired, a new cycle can now
be selected, by pressing Start and
closing the door immediately, the
new cycle will begin.
If you have selected your cycle and
options and decide to cancel, press
Cancel, the unit will go into a stand-
by mode and all LED lights will turn
o.
7
Control Lock
Control Lock locks the controls to
avoid accidental button presses, for
example while cleaning the control
panel.
To lock the control panel, press and
hold the Control Lock button. The
LED above the button blinks and
then stays lit when the controls are
locked.
When locked, all lights on the control
panel including the Control Lock
LED are o when the door is closed,
and only the control lock LED lights
when the door is opened.
To unlock the controls, open the
door and press and hold the Control
Lock button until it blinks and turns
o. The control panel shows the
selected last wash and dry cycle
after the controls are unlocked.
NOTE
If the Control Lock button is released
before it begins to blink the control
panel will remain locked. Hold the
control lock button until it stops
blinking and turns o to ensure the
controls have been unlocked.
NOTE
The start of the cycle times out if the
door is not closed immediately (within
4 seconds) after pressing START.
Loading ...
Loading ...
Loading ...