Loading ...
Loading ...
Loading ...
24 TROUBLESHOOTING
Dishes not Dry
• By selecting Heat Dry, High Temp
Wash or Sanitize options this will
improve drying.
• Make sure the rinse aid dispenser is
filled.
• Increase the discharge setting of
rinse aid. (See Rinse Aid).
• Check the incoming water
temperature. Be sure it is at least
120
o
F (49
o
C).
• Check for proper loading-avoid nesting
items.
• Plastic items may need to be towel
dried.
• Cups with a concave bottom will collect
water. Load them at the far left of the
upper rack so they will be held in a tilted
position.
• Containers, bowls, pots/pans, and any
dishware with concave surfaces that
can collect water should be placed
in the rack facing or angled down so
that water is able to drain even from
the lowest point.
Drying Tip
• Select the Normal Wash and High
Temp Wash pads along with a Rinse
Aid agent for improved drying
performance.
Glassware/Flatware Spotted or Cloudy
• Check water hardness. For extremely
hard water, it may be necessary
to install a water softener. (See
Detergent Chart).
• Water temperature may be low.
Avoid extremely low or high
temperatures. (See Factors Aecting
Performance).
• Avoid overloading and improper
loading. (See Preparing and Loading
Dishes).
• Use fresh detergent. Old detergent is
ineective.
• Make sure rinse aid dispenser is filled.
• Check to see that proper amount
of detergent is being used for cycle
selected. (See Detergent Dispenser).
• Home water pressure may be too
low-it should be 20 to 120 pounds per
square inch (psi).
Before You Call:
Before calling for service, review this
list. It may save you both time and
expense. This list includes common
experiences that are not the result of
defective workmanship or material in
your dishwasher.
Food Soils Left on Dishes
• Choose another cycle for longer
washing time.
• Check rack loading section for
proper loading-avoid nesting items.
• Do not overload the dishwasher (See
Preparing and Loading Dishes).
• Check to verify that the glass trap
is maintained and installed properly
(See Care and Cleaning).Home water
pressure may be too low-should be 20
to 120 pounds per square inch (psi).
• Check incoming water temperature.
It should be about 120
o
F (49
o
C). (See
Factors Aection Performance).
• Check water hardness. For extremely
hard water, it may be necessary
to install a water softener. (See
Detergent Chart).
• Use Fresh Detergent.
• Make sure items are not blocking the
spray arms, preventing them from
rotating.
NOTE
The control panel will timeout in 4
seconds if the START button is not
pressed after opening the door.
The start button must be pressed to
resume the wash if power is lost and
then restored during a running cycle.
If a power outage occurs during a wash
delay, the dishwasher restarts upon power
restoration. When the restart is complete,
upon opening the door, the remaining
delay time countdown shows up in the
status window.
If power is lost during cycle selection,
once power is restored, the control
panel lights up for 3 seconds while the
dishwasher starts up. After start-up
completes, cycle selections can then be
made if the door is open.
Loading ...
Loading ...
Loading ...