Loading ...
Loading ...
Loading ...
10
Features
12-hour automatic cancel
This safety feature turns off the oven if it has been left on for over
12 hours. This feature can be turned on or off.
• To allow operation for more than 12 hours: Turn knob to OFF.
Press and hold
MINS
+
and
MINS
-
.
Display will change from time of day to "OFF", and return to time of day.
• To set oven to shut off after 12 hours: Turn knob to OFF.
Press and hold
MINS
+
and
MINS
-
.
Display will change from time of day to "ON", and return to time of day.
Oven temperature control adjustment
Your new range is calibrated at the factory for temperature. Due to individual
variances and preferences, it may be necessary to adjust individual ovens
once they have been installed.
When first using the oven, follow recipe times and temperatures. Before
adjusting oven baking temperature, test a recipe by using a temperature set
higher or lower than the recommended temperature. The baking results should
help you to decide how much adjustment is needed.
NOTE: Remove aluminum foil from oven—it will alter oven performance.
Check for blocked heat vents. If it still appears the oven is not
performing as expected, a calibration may be done.
An accurate digital thermometer is necessary to calibrate the oven. Store
purchased oven thermometers do not measure temperature accurately.
1. Turn oven temperature knob to OFF.
2. Press and hold
HRS
+
and
HRS
-
for approximately 5 seconds.
3. Double digits will display ranging from -35 to 35. "00" is most common.
4. Immediately, press either
•
HRS
+
to increase oven temperature by 5°F
•
HRS
-
to decrease oven temperature by 5°F
• When temperature is adjusted to a cooler setting, a minus sign (-) will
display with the offset temperature.
5. When desired temperature change is displayed, release control and
change will be automatically saved after a few seconds. Control will
return to previous display. Temperature adjustment will be retained
through a power failure.
Service codes and tones
Electronic oven control is equipped with a self-diagnostic system.
Self-diagnostic system alerts you if there is an error or problem with the unit.
If the electronic range control sounds a series of beeps and display shows
an F-code, record the F-code shown and turn control to OFF. Some F-codes
can be cleared by disconnecting power to the range. If the code continues to
reoccur disconnect electrical supply to range and contact an authorized
servicer.
¸
F
-
code Warning
F2 Oven cavity over temperature
F3 Open circuit in oven
temperature sensor circuit
F4 Shorted circuit in oven
temperature sensor circuit
FFF Control failure
Loading ...
Loading ...
Loading ...