Loading ...
Loading ...
Loading ...
13
11. Set the console assembly (K) on the brackets on
the console base assembly (G). Do not pinch
any wires. Make sure that the wires (N, 81) are
inserted into the console assembly.
Attach the console assembly (K) with two
5/16" x 1 3/4" Screws (12) and two 5/16" Star
Washers (11); start both Screws, and then
tighten them. Note: Only one side is shown.
11
G
M
L
N, 81
K
10. With the help of a second person, hold the
console assembly (K) near the console base
assembly (G).
See the inset drawing. Connect the wire (L)
from the console base assembly (G) to the
wire (M) from the console assembly (K). The
connectors should slide together easily
and snap into place. If they do not, turn one
connector and try again. IF YOU DO NOT
CONNECT THE CONNECTORS PROPERLY,
THE CONSOLE MAY BECOME DAMAGED
WHEN YOU TURN ON THE POWER.
Locate the console wire (N) in the console
assembly (K). Connect the Upright Wire
(81) to the console wire. Insert the wires
(L, M) into the hole in the Console Base (64).
Insert the wires (N, 81) into the console assem-
bly (K) and position the wires on the decal.
L
M
G
K
81
64
N
10
11
12
Loading ...
Loading ...
Loading ...