Loading ...
Loading ...
Loading ...
Oven did not clean properly. . Longer cleaning time may be needed.
. Excessive spillovers, especially sugary and/or acidic foods, were not removed prior
to the self-clean cycle.
e
Oven door will not unlock after
self=clean cycle.
There are no beeps and
no display.
Moisture collects on oven
window or steam comes from
oven vent.
There is a strong odor or light
smoke when oven is turned on.
Ventilation system is not
capturing smoke efficiently.
Fault Codes
Noises may be heard.
SAb flashing and then
displayed continuously.
Oven interior is still hot. Allow about one hour for the oven to cool after the
completion of a self-clean cycle. The door can be opened when the LOCK indicator
word is not displayed.
The control and door may be locked. See pg. 6.
. Oven may be in Sabbath Mode. See page 25.
. This is normal when cooking foods high in moisture.
. Excessivemoisture was used when cleaning the window.
. This is normal for a new range and will disappear after a few uses. Initiating a clean
cycle will "burn off" the odors more quickly.
. Turning on a ventilation fan will help remove the smoke and/or odor.
. Excessivefood soils on the oven bottom. Use a self-clean cycle.
. Check on cross ventilation in room or make up air.
. Outside wall cap may be trapped shut.
. Range may be improperlyinstalled;check ducting information. See pg. 5.
. Air filter may be improperly installed. See pg. 14.
. The oven may detect a fault during programming or during operation. If a fault is
detected, the message FAULT DETECTED- PRESSPOWERTO CLEARor FAULT
DETECTED- PRESSENTERTO TRYAGAIN may appear. Follow directions in the display.
If the fault reappears or does not clear, call an authorized servicer or the toll-free number
inthe display.
. If the same operation is attempted before having the oven repaired, the message
FEATURENOT AVAILABLE will appear. The feature will remain inoperable until service
is obtained.
. If the oven is heavily soiled, excessive flareups may result ina fault code during cleaning.
Pressthe CANCEL pad and allow the oven to cool completely, wipe out excess soil, then
reset the clean cycle. If the fault code reappears, contact an authorized servicer.
. The oven makes several low-level noises. You may hear the oven relays as they go on
and off. This is normal.
. As the oven heats and cools, you may hear sounds of metal parts expanding and
contracting. This is normal and will not damage your appliance.
. Oven is inSabbath Mode. To cancel, press and hold the Setup pad for five seconds.
Cannot add another Favorite. . Favorites is full. To delete a favorite and add another, see page 23.
11
Loading ...
Loading ...
Loading ...