Loading ...
Loading ...
Loading ...
19
reached but not secured over time. myEcoReal Feel, once opti-
mal comfort is reached, PAC automatically modulates compres-
sor action and air ow, to keep it over time.
To activate the function, touch the button (D8) on remote
control and the myEcoReal Feel symbol appears.
After approx. 1 minute, the myEcoReal Feel indicator (C9) turns
on. It changes color when approaching the best comfort level
(see following diagram).
Please note: For this type of use, the appliance must be set up as
for air conditioning mode.
Perfect!
Perfect!
Perfect!
HUMIDITY
TEMPERATURE
HIGH
MEDIUM
LOW
HIGH
MEDIUM
LOW
Operating curve
Perfect!
Perfect!
ORANGE LIGHT: Room conditions far
from optimal level.
GREEN LIGHT: Most people feel good
room conditions, near optimal level.
BLUE LIGHT: Best comfort level.
• The well-being feeling is a subjective condition: for this
reason, dierent people may judge dierently the same
environmental conditions.
• In particularly severe environmental conditions (large size
of the environment, high temperature or humidity outside,
poor insulation of the room, too many of people or strong
heat load in the room, strong exposure to the sun ...) this
device may not be able to reach the best comfort level.
SILENT FUNCTION
(available in conditioning mode
only)
By activating this function, the operating noise is further re-
duced. To activate it, touch on the remote control the but-
ton (D2). The display shows the relative symbol (C12).
SWING FUNCTION
This function moves the ap evenly distributing the air into the
room.
When the Swing button (D9) is touched, the ap will begin
to move forwards and backwards alternatively.
If touched again, the ap will be locked into its current position.
When the button is next touched, the ap will start to move for-
wards and backwards again.
Please note: in order to avoid damaging the internal mecha-
nisms, the ap must not be moved manually.
REPEAT PAIRING OF CST REMOTE CONTROL
The CST remote control is already paired to the bundled Pinguino
appliance. In case the user wants to perform a pairing with an-
other Pinguino device, or in case of a pairing of brand new CST
remote control, the user needs to put the unit in Stand-by mode
and keep touched for 10 sec sthe MODE selection button (D6) on
the CST remote control. The Led (D10) starts blinking periodi-
cally indicating the pairing phase.
The user is then asked to press for 10 sec the button (C3) on
the Pinguino unit until a double beep is emitted. The pairing
phase is signaled on display by means of a fast ashing of the
dot in the middle of the digits.
When the two devices complete the pairing dialogue, the PAC
emits a double ‘beep’, the display will show the normal visualiza-
tion for Standby. The pairing must be done within 60 sec.
SETTING THE TIMER
The timer allows the delayed start up or shut down of the appli-
ance. This function will prevent wasting electricity by optimising
the operating periods.
How to program delayed shut down
• While the appliance is on in any operating mode, delayed
shut down can be programmed.
• Touch the
C1C2
C4
C11
C13
C12
C9
C7
C5
C6
C3
C16
C14
C10
C15
C17
C8
timer button (D5): the timer symbol
(C15) and hours (C16) light up.
Loading ...
Loading ...
Loading ...