Vevor TS181A User Manual

Loading ...

- 24 -

Target ID Cursor

bounces

If Target ID Cursor bounces erratically, the detector may

have detected a junk object or the metal signal is too weak.

However, Target ID Cursor may bounce if a good target

( such as a coin ) is not parallel to the search coil or the

target is below the edge of the search coil. Target ID Cursor

may also bounce if there is one or several junk objects

existing beside the good target. Move the search coil from

different directions until Target ID Cursor becomes more

stable.

Note:

Large iron plates, depending on their orientation in the soil,

can read as a good target or cause Target ID Cursor to move

erratically.

BATTERY REPLACEMENT

The battery level indicator on the display indicates the present level of the

batteries. Four bars ( ) indicates that the batteries are high. To avoid

performance decrease or abnormal operation, replace the batteries

immediately when the battery level indicator becomes " " ( there is no

bar on the indicator ).

To replace the batteries, turn off the detector first. Then slide down the

battery cover, which is on the front of the control box ( refer to Figure 4 ), to

remove the battery cover. Replace the old batteries with new ones of the

same type, make

sure that the polarity connections are correct ( see the polarity indications

at the bottom of the battery compartment ). Reinstall the battery cover.

Loading ...

Vevor TS181A Metal Detector for Adults & Kids, 10 Inch Waterproof Search Coil