Loading ...
Loading ...
Loading ...
14
Assembly, Operation & Maintenance Instructions
Angle the assembly slightly to the back and remove both M6x20mm screws, then do the
same at the front, supporting the parts so they don’t drop. Keep all of the fasteners for
later use. Removable stickers at the front and rear will mark the positions of these screws.
Remove the hood and barbeque chassis assembly from the stand top and place on the
ground.
STEP 03
/ Take the stand top (01B) and place it upside down (leg stumps up) on a clean surface
(note: there is no front or rear to this part). Take the right front leg (04 with a screw
hole in the foot) and slot it over the rear right corner stump. Fix in place using a M6 x
12mm screw (A) and at washer (E), but do not tighten. Take the right rear leg (05 with
a screw hole in the foot) and slot it over the front right corner stump. Fix in place using a
M6 x 12mm screw (A) and at washer (E), but do not tighten.
Take the left front leg (02) and slot it over the rear left leg stump. Fix into place using a
M6x12mm screw (A) and at washer (E), but do not tighten. Take the left rear leg (03)
and slot it over the front right leg stump. Fix into place using a M6x12mm screw (A) and
at washer (E), but do not tighten.
STEP 01
/Open the hood and x the hood handle (14) using two M5x30mm screws (F), two Ø5mm
spring washers (C) , two Ø6mm at washers (E) and two Ø5mm bre glass washers (G).
Tighten in place
STEP 02
/ The hood and barbeque chassis assembly is transported screwed to the stand top by four
M6x20mm screws and four Ø6mm spring washers (two at the front and two at the rear).
Before attempting to build the stand, the stand top should be removed.
14
C
F
G
E
Loading ...
Loading ...
Loading ...