Loading ...
Loading ...
Loading ...
Note: Refer to
Technical data on page 35
for
recommended oil for R 316TX and R 316TX AWD, R
316TsX AWD.
To lubricate the belt adjuster
The belt adjuster must be lubricated regularly with a
good quality molybdenum disulphide grease.
1. Remove the 2 screws that hold the belt shield and lift
it off.
2. Lubricate with a grease gun through the nipple at the
right side, below the lower belt pulley. Lubricate until
grease is pushed out of the rear side of the nipple.
3. Attach the belt shield and tighten the 2 screws.
Troubleshooting
Troubleshooting schedule
If you cannot find a solution to your problems in
this owner's manual, speak to your Husqvarna service
agent.
Problem Cause
The starter motor does not turn
the engine over
The parking brake is not applied. See
To apply and release the parking brake on
page 18
.
The lift lever for the cutting deck is in mow position. See
To lift and lower the
cutting deck on page 15
.
The main fuse is blown. See
To replace the main fuse on page 24
.
The ignition lock is defective.
The connection between the cable and the battery is bad. See
Battery safety on
page 12
.
The battery is too weak. See
To charge the battery on page 24
.
The starter motor is defective.
The engine does not start when
the start motor turns the engine
over
There is no fuel in the fuel tank. See
To fill fuel on page 14
.
The spark plug is defective.
The ignition cable is defective.
There is dirt in the carburettor or fuel line.
30 844 - 011 - 08.11.2022
Loading ...
Loading ...
Loading ...