Loading ...
Loading ...
Loading ...
2. Release the clip on the front cover with the tool
attached to the ignition key, and remove the cover.
3. Loosen the tension on the tension wheel for the drive
belt. (A)
C
B
A
4. Hold the spring handle with your left hand and
remove the drive belt with your right hand.
5. Pull the drive belt to the rear below the product. Do
not put it in the belt holder (B).
6. Put the spring handle in the spring holder to prevent
that the spring falls down.
7. Lift the cutting height stay and put it in the holder for
the cutting height stay (C).
8. Hold the front edge of the cutting deck with two
hands and pull until it stops.
9. Lift the service lock to vertical position.
WARNING: The lock
mechanism can cause injury to
fingers if you do not operate it
carefully. Hold the front edge of the
cutting deck with two hands when
you continue to the next step.
10. Lift the front of the cutting deck until the service lock
touches the frame and pull the cutting deck out.
Operation
Introduction
WARNING: Before you operate the
product, you must read and understand the
safety chapter.
To start to use Husqvarna Connect
1. Download the Husqvarna Connect app on your
mobile device.
2. Register in the Husqvarna Connect app.
3. Do the instruction steps in the Husqvarna Connect
app to connect and register the product.
To fill fuel
WARNING: Gasoline is very
flammable. Be careful and refuel outdoors,
refer to
Fuel safety on page 11
.
WARNING: Do not use the fuel tank as
a support area.
CAUTION: Incorrect type of fuel can
result in engine damage.
The engine runs on gasoline with a minimum octane
rating of 91 RON (87 AKI), not mixed with oil. We
recommend biodegradable alkylate gasoline. Do not use
gasoline that contains more than 10% ethanol.
14 844 - 011 - 08.11.2022
Loading ...
Loading ...
Loading ...