Husqvarna R 316TSX AWD R 316TsX AWD Rider

Operator's Manual - Page 29

For R 316TSX AWD.

PDF File Manual, 164 pages, Download pdf file

Loading ...
Loading ...
Loading ...
To replace the engine oil and the oil
filter
If the engine is cold, start the engine for 1–2 minutes
before you drain the engine oil. This makes the engine
oil warm and easier to drain.
WARNING: Do not operate the engine
for more than 1–2 minutes before you drain
the engine oil. The engine oil becomes very
hot and can cause burn injuries. Let the
engine become cool before you drain the
engine oil.
WARNING: If you spill engine oil on
your body, clean with soap and water.
1. Put a container below the oil drain plug on the left
side of the engine.
2. Remove the dipstick.
3. Remove the oil drain plug.
4. Let the oil run out into the container.
5. Attach the oil drain plug and tighten it.
6. Turn the oil filter counterclockwise to remove it.
7. Lightly lubricate the rubber seal on the new oil filter
with new oil.
8. To attach the oil filter, turn it clockwise by hand until
the rubber seal is in position, then tighten a half turn
more.
9. Fill with new oil as given in
To do a check of the
engine oil level on page 28
.
-20°C -10°C 20°C10°C 30°C 40°C0°C
-4°F -14°F 68°F50°F 86°F 104°F32°F
SAE40
SAE30
SAE10W-40
SAE10W-30
SAE5W-20
10. Start the engine and let it idle for 3 minutes.
11. Stop the engine and make sure that the oil filter does
not leak.
12. Fill with oil to compensate for the oil held in the new
oil filter.
To do a check of the transmission oil
level
1. Remove the two screws, one on each side, and lift
off the transmission cover.
2. Make sure that the oil level in the transmission oil
tank is between the two horizontal lines on the tank.
3. Fill with engine oil if the oil level is below the lower
line, but do not fill above the top line.
844 - 011 - 08.11.2022
29
Loading ...
Loading ...
Loading ...