Loading ...
Loading ...
Loading ...
To reinstall the head restraints, proceed as follows:
1. Hold down both the adjustment button and release
button while placing the head restraint posts into
the holes.
2. Then, reposition the head restraint to the appropri-
ate height for the passengers.
3. Replace the seatback to the appropriate position for
passengers.
NOTE:
The rear center head restraint is fixed, and is not
adjustable or removable.
WARNING!
•
A loose head restraint thrown forward in a collision
or hard stop could cause serious injury or death to
occupants of the vehicle. Always securely stow
removed head restraints in a location outside the
occupant compartment.
•
ALL the head restraints MUST be reinstalled in the
vehicle to properly protect the occupants. Follow
the preceding reinstallation instructions prior to
operating the vehicle or occupying a seat.
UCONNECT VOICE RECOGNITION QUICK
TIPS — IF EQUIPPED
INTRODUCING VOICE RECOGNITION
Start using Uconnect Voice Recognition with these help-
ful quick tips. It provides the key Voice Commands and
tips you need to know to control your vehicle’s Voice
Recognition (VR) system.
BASIC VOICE COMMANDS
The following Voice Commands can be given at any
point while using your Uconnect system.
Push the Voice Recognition (VR) button. You can also
say the Wake Up word “Hey, Dodge” or “Hey, Uconnect”.
After the beep, say:
•
“Cancel” to stop a current voice session.
•
“Help” to hear a list of suggested Voice Commands.
•
“Repeat” to listen to the system prompts again.
Notice the visual cues that inform you of your Voice
Recognition system’s status.
GET STARTED
The VR button is used to activate/deactivate your Voice
Recognition system. You can also use the system’s
“Wake Up” word to activate voice recognition. The Wake
Up word can be set through the Uconnect Settings
page 145.
Helpful hints for using Voice Recognition:
•
Reduce background noise. Wind noise and passen-
ger conversations are examples of noise that may
impact recognition.
•
Speak clearly at a normal pace and volume while
facing straight ahead.
•
Each time you give a Voice Command, first push the
VR button or say the Wake Up word, wait until after
the beep, then say your Voice Command.
•
You can interrupt the help message or system
prompts by pushing the VR button and saying a
Voice Command from the current category.
•
You can also interrupt the help message or system
prompts by speaking. This feature is called “barge-
in” and can be set through the Uconnect Settings
page 145.
Uconnect Voice Command Buttons
1 — For Vehicles Equipped With Navigation: Push The
Voice Recognition Button To Begin Radio, Media,
Navigation, Climate, Start Or Answer A Phone Call, And
Send Or Receive A Text
1 — For Vehicles Not Equipped With Navigation: Push
The Phone Button To Answer An Incoming Phone Call
GETTING TO KNOW YOUR VEHICLE 51
2
Loading ...
Loading ...
Loading ...