Loading ...
Loading ...
Loading ...
1. Position the watch so its right (rotary
switch) side is aligned with the small claw
of the charger.
Small claw
2. Secure the left side of the watch with the
large claw of the charger.
Large claw
●
Make sure that the claws of the charger
securely grasp the watch, and that the
watch is in close contact with the
charger.
●
Charging may fail if there is space
between the charger and watch. Also,
foreign matter can get into the space
and cause overheating of the watch
and/or charger.
3. Turn on your computer or other device
with a USB port (power source), and
connect the USB cable to it.
4. Connect the other end of the USB cable to
the charger.
Press down on the watch and charger
when connecting the USB cable to the
USB port to ensure that they do not
separate from each other.
●
This starts charging and causes
to
appear on the watch display.
●
disappears from the display when a
full charge is achieved.
●
Precautions When Charging
●
GPS signals (for time adjustment, log
acquisition, point memory, etc.) are not
received while charging with the charger is
in progress.
●
The watch’s GPS function will not be able to
be used for about one minute after you
remove it from the charger. During that
period the watch also will not be able to
detect whether it is connected to or
disconnected from the charger.
●
Do not attempt charging at high ambient
temperatures of 35°C or greater. The watch
becomes hot during charging, which will
cause charging to stop. High ambient
temperature may result in a less than full
charge.
●
Do not carry the charger in a bag or
otherwise subject it to squeezing or
crushing forces. Doing so can cause
deformation of the claws so they become
open too far, making it impossible to attach
the watch to the charger.
●
If an ongoing charging operation stops,
remove the watch from the charger and
disconnect the USB cable. After checking
for and eliminating problems, try charging
again.
●
It may take some time for charging to start
after the watch is attached to the charger.
●
The watch and charger may become warm
during charging. This is normal and does
not indicate malfunction.
Note
●
It takes about five hours for charging to
start after the watch’s display goes
blank.
●
Charging time depends on ambient
temperature and other factors.
Charging Time Guidelines
Charging each day for the approximate times
shown below should be enough to maintain a
charge of
or higher.
At a charge of , all watch functions are
supported, except for GPS.
l
Checking the Charge Level
Note
●
Actual charging time depends on the
local charging environment.
Solar Charging
Sunny day, outdoors (50,000 lux): 12 minutes/
day
Sunny day, near a window (10,000 lux): 45
minutes/day
Overcast day, near a window (5,000 lux): 72
minutes/day
Note
●
Charging is performed even with
exposure to indoor fluorescent lighting
(500 lux). The watch will be able to
maintain a charge of or higher if it
is exposed to indoor fluorescent
lighting for eight hours a day, in
addition to light near a window on a
sunny day (10,000 lux) for two hours a
week.
Charging with the Charger
1 minute/day
Operation Guide 3452
6
Loading ...
Loading ...
Loading ...