Loading ...
Loading ...
Loading ...
8. Repeat the steps below to change the
value.
●
Rotate the rotary switch to change the
underlined value.
●
Use (D) to move the underlining to the
value you want to change.
Rotary Switch
●
To cancel the setting operation, perform
the steps below.
A
Press (C).
B
Rotate the rotary switch to select
whether or not you want to save the
current settings.
[YES]: Current settings saved
[NO]: Current settings not saved
C
Press the rotary switch.
9. Press the rotary switch to exit the setting
screen.
This completes the calibration operation
and returns to the Barometer/
Temperature Mode setting screen.
10. Press (C) to exit the setting screen.
Calibrating Temperature
Readings
The watch’s temperature sensor is adjusted at
the factory and normally does not require
calibration. However, you can calibrate the
displayed value if you notice major errors in
readings.
Important!
●
Check to make sure that the value you
use for calibration produces correct
temperature readings.
●
Before calibrating the temperature
reading, remove the watch from your
wrist and leave it in the area where you
plan to measure temperature for about
20 or 30 minutes to allow the case
temperature to become the same as
the air temperature.
1. Press (A).
This displays the Barometer/
Temperature Mode setting screen.
Rotary Switch
2. Rotate the rotary switch to move the
pointer to [CALIBRATION].
3. Press the rotary switch.
4. Rotate the rotary switch to move the
pointer to [THERMOMETER].
5. Press the rotary switch.
6. Rotate the rotary switch to move the
pointer to [MANUAL].
●
Selecting [OFFSET OFF] returns
barometric pressure calibration to its
factory default state.
7. Press the rotary switch.
8. Repeat the steps below to change the
value.
●
Rotate the rotary switch to change the
value or the sign where the underlining
is located. To specify a sub-zero value,
display the minus (-) sign.
●
Use (D) to move the underlining to the
value you want to change.
Rotary Switch
●
To cancel the setting operation, perform
the steps below.
A
Press (C).
B
Rotate the rotary switch to select
whether or not you want to save the
current settings.
[YES]: Current settings saved
[NO]: Current settings not saved
C
Press the rotary switch.
9. Press the rotary switch to exit the setting
screen.
This completes the calibration operation
and returns to the Barometer/
Temperature Mode setting screen.
10. Press (C) to exit the setting screen.
Changing Displayed
Information
You can use the procedure below to display a
barometric pressure graph in the Barometer/
Temperature Mode.
1. Press (A).
This displays the Barometer/
Temperature Mode setting screen.
Rotary Switch
2. Rotate the rotary switch to move the
pointer to [SCREEN].
3. Press the rotary switch.
Operation Guide 3452
25
Loading ...
Loading ...
Loading ...