Loading ...
Loading ...
Loading ...
● To delete a log
1. Press (A).
Rotary Switch
2. Rotate the rotary switch to select a delete
method.
[ONE]: Delete only the currently selected
log.
[ALL]: Delete all logs.
3. Press the rotary switch.
This deletes the log(s).
●
If you selected [ALL], press the rotary
switch again to delete. Delete will also
be executed automatically after about
10 seconds, even if you do not press the
rotary switch again.
4. Press (C) as many times as necessary to
return to the GPS Navigation Mode setting
screen.
Note
●
Acquired log data can be transferred to
a phone for more detailed viewing of
routes traveled, etc.
Setting the GPS Signal
Receive Interval
Use the procedure below to specify the
interval for GPS signal reception and position
information acquisition during navigation.
1. If a navigation operation is in progress,
stop it.
l
Stopping Navigation
2. Press the rotary switch.
Rotary Switch
3. Rotate the rotary switch to move the
pointer to [SETTING].
4. Press the rotary switch.
5. Rotate the rotary switch to move the
pointer to [INTERVAL].
6. Press the rotary switch.
7. Rotate the rotary switch to display the
GPS receive interval you want to use.
[NORMAL]: Acquires location information
every minute.
[HIGH RATE]: Acquires location
information every few seconds.
8. Press the rotary switch.
9. Press (C) as many times as necessary to
return to the GPS Navigation Mode setting
screen.
Note
●
The amount of time that navigation can
be used depends on the receive
interval setting. When you want to
perform long-term continual
navigation, select the [NORMAL]
setting.
[NORMAL]: 24 hours, continuous
[HIGH RATE]: 4 to 5 hours, continuous
Specifying the Distance Unit
1. If a navigation operation is in progress,
stop it.
l
Stopping Navigation
2. Press the rotary switch.
This displays the GPS Navigation Mode
setting screen.
Rotary Switch
3. Rotate the rotary switch to move the
pointer to [SETTING].
4. Press the rotary switch.
5. Rotate the rotary switch to move the
pointer to [UNIT].
6. Press the rotary switch.
7. Rotate the rotary switch to select the
distance unit.
[KILOMETER]: Kilometers
[MILE]: Miles
8. Press the rotary switch.
9. Press (C) to return to the GPS Navigation
Mode setting screen.
Digital Compass
You can use the Digital Compass Mode to
determine the direction of north, and to check
your bearing to a destination.
Important!
●
Check the information below to find out
how to ensure correct readings.
l
Calibrating Compass Readings
l
Digital Compass Reading
Precautions
Getting ready
Enter the Compass Mode.
l
Navigating Between Modes
●
Entering the Compass Mode starts
compass readings.
Taking a Compass Reading
Point 12 o’clock in the direction of your desired
objective, and will indicate north. The
bearing and bearing angle to your objective
will also appear on the display.
●
Even if the watch is not level when you take
a reading, an auto level correction function
will automatically compensate for the angle
and display a result. Note, however, that if
the watch is positioned so its display is
nearly perpendicular to the ground, the
angle display will go blank and the watch will
not perform bearing measurement.
●
To retrigger the compass operation, press
(D).
Interpreting Bearing Readings
214°
0°
Bearing to objective
Bearing angle to
objective
North
Bearing
Objective
Directions: N (North), E (East), W (West), S
(South)
Operation Guide 3452
17
Loading ...
Loading ...
Loading ...