Loading ...
Loading ...
Loading ...
l
t
f
r
i
I
I
t
I
I
I
1
1
1
1
J
!
1
1
1
t
i
1
i
!
1
l
t
l
SERVICE SAFETY conL
;2. Toot service must be pertormed only at a Sears Parts and Repair Center_ Service
or maintenance performedby unqualifiedpersonnelcould resultin s risk of tniury,
3, When servicing a toot, use only Identlcal replacement parts, Follow instructions
tn the maintenance section of this manual Use of unauthorizedparts or failureto
followmaintenance Instructionsmay create a risk ofefectdc shock or injury,
SPECIFIC SAFETY RULES FOR CORDLESS DRILL/DRIVERS
I _Know your cordless drlll/drlvero Read operator's manual carefully_ Learn its
applications and limitations, as well as the specific potential hazards related to
this toot. Following this rule wilt reduce the rlsk of electric shock, fire, or
serious Injury.
2 BE SURE that twist drill bits, screwdriver bits and other accessory attachments ere
properly and securely mounted in the chuck jaws BEFORE operating the drill / driver°
3..ALWAYS carefully inspect the material you are going to drtlt/ drive into. Drilling/driving
into nails, pipes and electrical wires can cause serious personal injury
4 HOLD DRI[.LI DRIVER by insulated gripping surfaces (handles) when performing
an operation where the toot may drttl/ drive Into hidden wiring. Contact with a
"live" wire wLt!make the exposed me_al pads of lhe tool "tive" and shock the operator
5. NEVER hold the piece being drilled In your hands or across your togs.
It is impodant to support sad clamp the workpieoe properly in order to minimize body
exposure, bit binding, or toss of control
6. Maintain a firm grip on the drill/driver lo resist stadtng torque.
7. Use sharp accessory bile on_y. For drilling in WOOD use twist drill bits, spade bits,
or power auger btts oFor METAL use high*speed steel twist drill bits For MASONRY
use carbide-tipped bits. For PLASTIC use Iow dd!ting speeds for maiedal wttha low
melting point, For SCREWDRIVtNG use the proper size screwdrtvtng bit for the
screwdrivlng application such as Phillips, slotted and square recess bits.
8. BE SURE the material to be drilled is stationary, anchored or clamped firmly. If drilling
thin material, use a back.up block to prevent damage to the material,
9. ONLY USE the specifically designated battery pack that was included with this
drill I driver and charging stand/transformer. Use of any other battery packs may
create a risk of injury and f]rao
10 Cordless tools do not have to be plugged Into an electrical outlet; therefore,
they are always in operating condition, Be aware of possible hazards when not
using your batter' t operated tool or when changing eccesaortes_ Following this
rule will reduce the risk of electric shock, fl_e, or serious personal intury
11 Do not place battery tools or their batteries near fire or heat, This will reduce the
risk of explosion end possible injury
12, Do not crush, drop or damage battery pack. Never use a battery pack or charging
stand!transformer that has been dropped or received a sharp blow. A damaged
battery peck is subjec! to explosion. Properly dispose of a dropped or damaged battery
pack immediately,,
7-11-07
Loading ...
Loading ...
Loading ...