Craftsman 17211810 drill

User Manual - Page 22

For 17211810.

PDF File Manual, 64 pages, Download pdf file

Loading ...
Loading ...
Loading ...
OPERATION AS A DRILL (Fig_ 13) cool
10. If lhe drilVdriver staffs, or the bit j_ms in lhe workpiece, it is _sually because the dril_/driver
is being overloaded RELEASE TRIGGER SWITCH IMMEDIATELY and remove bit from
werkptece Determine cause e! stalling+ DO NOT PRESS TRIGGER OFF AND ON IN AN
ATTEMPT TO START A STALLED DRILL/DRIVER -THIS COULD DAMAGE THE
DRILL/DRIVER.
1t Keep Ihe motor running when pulling the btt back out o! a drilled hole This will help prevent
jamming_
Z_ WA RNING:Be prepared for binding at bit breakthrough. When these situations
occur, dr+lVdrlver has a tendency to grab and kick opposite to the direction of rotation
and could cause loss of control when breaking through materlaI_ If not prepared_ this
loss of conLrol ooukJ resul! in possible serious In)ury.
I NOTE: This drllVdrtver has an electric brake. When the trigger switch is released, the /
1
chuck stops turning Instantly° When the brake is functioning properly, sparks will be
/visible through the vent stets on the housing, This is normal and Is the action el the brake,
OPERATION AS A SCREWDRIVER ............
(Fig. 14)
Turn and set the torque clulch eerier to the
desired torque setting, I through 2,3. Install
and tighten the desired fastener accessory
bit inlo the chuck.
1. tnstal_ the b_ttery pack into the drilltdriver+
2+ Push the lorwardtreverse seloctor switch
to the forward posilion.
3+,Make a few practice runs, driving screws in
scrap material to make sure you have the
clutch so! at the proper torque setting for
your job.
4+When all adjustments are correct, drive
and tighten your fasteners.
5+.To remove fasteners, push forwardlreverso selector swilch Io the reverse position+
I _ WARNING: When servicing, use only identical Craftsman replacement I
parts+Use of soy other part may create a hazard or cause produot damage.
i Z_ WARNING: ALWAYS wear safety goggles or safety glasses with side ]
shields when using compressed air to clean toots, tf the operation is dusty,
also we_r a dust mask+
22
I
+
I
+
+
+
1
l
1
!
l
1
t
l
t
l
I
1
]
l
l
I
t
!
l
i
l
1
Loading ...
Loading ...
Loading ...