Loading ...
Loading ...
Loading ...
,.-1
CHARGINGTHE BATTERY PACK (Fig° 4 and 4a)
All Models
The battery pack lot this tool has been shipped in a low charge condilion to prevent
possible problems. Therefore, you should charge overnight prior to use..
I NOTE: Batteries wtll not reach full charge the first ttme they are charged.
Allow several cycles (operation followed by recharging} for them to become
fully charged.
1 Charge battery pack onfy with the charging
stand f transformer that was supplied wilh
this drill/ driver.
2 Make sure power suppty is normal
household voltage. 120 volls, 60 Hz.
AC,onty,
3 Connect charging stand's transformer Io
power supply.
4 Place battery pack in charging stand., Align
raised rib on battery pack with groove In
charging stand (See Fig 4).
5, Press down on battery pack to be sure
contacls on battery pack engage properly
with contacts in charging stand,
6The charging stand has two (LED) indicator
lights, one green and one red
When a battery pack ls put into the charging
stand, the red LED wtll light,
indicating that the battery pack is charging
properly (see Fig 4a),
When the battery pack is charged and
removed Irom the charging stand, the red
light will go Off The green LED will come on
only when there is a problem with the
battery or charger,,
7 After normal use, 3 hours or less of charging
time ts required to fu]ty recharge battery
Fig. 4
Transformer
pack IIbattery pack iscompletely discharged, 6 hours or longer of charging time is
required to fully recharge battery pack,
I OTE: Within the warranty period, tf the charglng stand LED lights do not
operate properly, or the charging stand does not charge the battery pack, return
the charging stand / transformer and battery pack to your nearest Sears Store or
other Craftsman outlet for free replacement°
15
7-11-07
Loading ...
Loading ...
Loading ...