Loading ...
Loading ...
Loading ...
CHARGINGTHE BATTERY PACK conL (Fig. 4 and 4a)
B.The battery pack wift becomeslightiy warm to the touch while charging This is normal
anddoes not indicatea problem,
9. Do not place the battery chargingstand t transformer tn an area of extremeheat or cold,
itwillwork best at normal room temperalure.
10. When baitery pack becomes fuIly charged, unplug battery charging stand I lransformer
from powersupply and remove lhe battery pack.
L_ CAUTION: If at any time during the charging process the green LED
light ls iIlumtneted, remove the battery pack tram the charging stand. Replace
the battery pack, and if the green LED light still comes on, take the charging
stand t transformer In to be repaired / replaced.
L_ CAUTION: If at any point during the charging process neither of the LEDs
are lit, remove the batter=/pack from the charging stand to avoid damaging the
producL Do not insert another battery,, Return the charging stand / translormer
and battery pack to your nearest service center for service or replacement.
CHARGING A HOT BATTERY PACK
When using your tool continuously, the batteries in your batlery pack will become hot
You should let a hot battery pack coot down for approximately 30 minutes before
attempting to recharge-
NOTE: A hot battery pack only occurs when prolonged continuous use of your drill/driver
causes the batterfes to became hot. It does net occur with typical use.Within the
warranty period, if the battery pack becomes hot with typical use, return the charging
stand/kansformer, and battery pack to your nearest Sears store or other Craftsman outlet
for free replacemenL
INSTALLING THE BATTERY
PACK IN DRILL/DRIVER (Fig. 5)
t. Place the Forward / Reverse Selector Swttch
wlth Power Lock-Off inlo the center posilion to
lock the power off,
2. Place lhe battery pack in the drill, aligning the
raised rib on battery pack with groove inside
the drill,
3 Make sure the latches on each side of the
battery pack "snap" into place, and the batlery
pack is secured tn the drill I driver before
beginningoperation.
16
Loading ...
Loading ...
Loading ...