Loading ...
Loading ...
Loading ...
MAINTENANCE
WARNING: FOR YOUR OWN SAFETY, TURN
SWITCH "OFF" AND REMOVE PLUG FROM
POWER SOURCE OUTLET BEFORE MAINTAIN-
ING OR LUBRICATING YOUR SAW,
Do not allow sawdust to accumulate inside the saw.
Frequently blow out any dust that may accumulate
inside the saw cabinet and the motor.
Frequently clean you cutting tools with Craftsman
Gum and Pitch Remover.
A coat of automobile-type wax applied to the table
will help to keep the surface clean and allow
workpieces to slide more freely.
If the power cord or motor cord is worn or cut, or
damaged in any way, have it replaced immediately.
Make sure the teeth of the ANTIKICKBACK pawls
are always sharp. To sharpen:
1. Remove blade guard.
2. Rotate pawl toward rear of spreader so that
teeth are above top of spreader.
3. Hold spreader with left hand and place pawl
over corner of workbench.
4. Using a small round file (Smooth Cut) sharpen
the teeth.
\
\
\
LUBRICATION
0
\
0
©o
The following parts should be oiled occasionally
with SAE No. 20 or No. 30 engine oil.
1. Tilt screw threads and pivot nut. (First Clean
with Craftsman Gum & Pitch Remover.)
2. Elevation screw threads and pivot nut. (First
Clean with Craftsman Gum & Pitch Remover.)
3. Cradle bearing points.
4. Bearing points in guard assembly, miter gauge
and rip fence.
\! :. ...
©
0
C
0
o
---O
GUARD
ITER GAUGE
_fr BEARING POINTS
41
Loading ...
Loading ...
Loading ...