Loading ...
Loading ...
Loading ...
blade at 90 ° to the table and at zero elevation
accurately sets the program that computes
the elevation and bevel angle of the blade.
Once the calibration has been set the key
becomes an "Enter" key used for entering
both a bevel and an elevation programmed
motion.
D. The _ key, when pressed, will starta
programmed motion.
It becomes inactive while the saw motor is
"ON".
E The _ keywillsetthedisplaytoa"zero"
point other than at the table top, or when
using a cutting tool less than 10 inches in
diameter. See "Calibrating the Saw for
Electronic Operations" Page 29.
F. The _ key will clear the display if an
error is made in a programmed entry and will
return the display to the current position of
the chosen function. This key will also stop a
programmed motion once begun and clear
the original destination.
5. NUMBER KEYS:
Bmm
mmM
Rim
mMD
These keys include the number keys _}
through _ . the decimal point _ and
The number used to enter
keys,
keys
are
a destination for programmed motion. The
decimal point is used when entering the decimal
part of the number.
The [_ key ispressedafterthenumbersare
entered if a destination is desired below •the
"zero" location
A lighted dot in the upper left hand corner of the
display indicates "min us."
6. RIP FENCE... is locked in place by tightening
the lock knob. To move the fence, loosen the
knob and grasp the fence with one hand at the
front,
Holes are provided in the rip fence for attaching
a wood facing when using the dado head, or
molding head.
Select a piece of smooth straight wood approx.
3/4" thick, at least as long as the rip fence, and at
least 7-1/2" wide (high) to permit clamping of
featherboards.
Attach it to the fence with three Round Head #10
Wood Screws 2 in. long. To remove the facing,
loosen the screws, slide the facing backward
and pull the screws through the round holes.
WOOD FACING
'\
,/ j/"/
ROUND HEAD ./
# 10 WOOD SCREWS
If-you are making a np type cut in material
thinner titan 3/16 in. while the fence is
positioned over the depressed area of table
extension, the facing should be attached to the
fence so that the bottom edge touches the top
surface of the extension• In this case, the facing
must be shorter than the fence. This will prevent
thin material from sliding under the rip fence.
,
MITER GAUGE... head is locked in position
for crosscutting or mitering by tightening the
lock knob. ALWAYS LOCK IT SECURELY
WHEN IN USE.
LOCK KNOB
\
STOP PIN 45 ° SLOT \
FOR STOP PIN
\
AUXILIARY FACING
There are slots for the stop pin at the 45 degree
right and left positions for conveniently setting
the Miter Gauge to cut miters.
NOTE: The slots for the stop pm and the
graduations are manufactured to very close
tolerances which provide accuracy for average
woodworking. In some cases where extreme
accuracy is required make a trial cut and then
recheck it.
If necessary, the miter gauge head can then be
swiveled slightly to compensate and then
locked.
Slots are provided in the miter gauge for
attaching AUXILIARY FACING to make it easier
to cut long pieces• Be positive facing does not
interfere with the proper operation of the
sawblade guard.
Select a suitable piece of emooth _traight wood
• . drill two holes through it and attach it with
screws.
NOTE: When bevel crosscutting, attach facing
so that it extends to the right of the miter gauge
and use the miter gauge rn the groove to the
right of the blade.
25
Loading ...
Loading ...
Loading ...