Loading ...
Loading ...
Loading ...
MOTOR CONNECTIONS
WARNING: FOR YOUR OWN SAFETY, NEVER
CONNECT PLUG TO POWER SOURCE OUTLET
UNTIL ALL ASSEMBLY STEPS ARE COMPLETED
1. Open motor connector box cover located on left
end of motor (viewed from rear of saw) using a flat
blade screwdriver.
2. Remove GREEN SCREW and Iockwasher and
insert screw through round metal terminal on the
end of the GREEN wire of power cord with
Iockwasher between terminal and motor frame.
(See illus.)
3. Reinsert GREEN SCREW in the threaded hole.
Tighten securely.
4. Insert terminal end of WHITE wire on spade
terminal marked T4 on the motor. Push terminal
firmly until seated.
5. Insert terminal end of BLACK wire on spade
terminal marked T1 on the motor. Push terminal
firmly until seated.
6. Close motor connector box being sure that power
cord is seated in the largest strain relief groove,
and tighten box cover screws:
WARNING: Do not plug In power cord.
7. Do not install pulley or belt at this time.
L¢
GREEN
INTERNAL
TERMINAL
GREEN WIRE
.TO GREEN SCREW
STRAIN RELIEF
)VE
ITE WIRE TO
TERMINAL T4
ATTACHING AND ASSEMBLING
TABLE EXTENSIONS
If you received Table Extensions with your saw
attach them at this time.
From among the loose parts find the following
hardware: (Quantity indicated is for 2 extensions)
Ref.
No. Description Qty.
1 Corner Support Bracket ............. 4
2 Corner Stiffener Bracket 4
3 Truss Hd. Screw, 1/4-20 x 1 ......... 16
4 External Lockwasher, 1/4 ............ 16
5 Hex Nut, 1/4-20 ..................... 16
6 Flat Washer (Dia. of Hole 17/64) ..... 4
HARDWARE FOR INSTALLING
EXTENSIONS TO SAW TABLE
7 Hex Hd. Screw, 5/16-18 x 1-1/4 ...... 8
8 External Lockwasher, 5/16 ........... 8
9 Hex Nut, 5/16-18 .................... 8
10 Flat Washer (Dia. of Hole 11/32) ..... 8
Assemble brackets with hardware as listed.
Insert eight (8) 5/16-18 x 1-1/4 in. long screws
through holes in EXTENSION then through table.
Install flat washer, Iockwashers, and screw on the
nuts... DO NOT TIGHTEN.
Align front edge of extension with front edge of saw
table. Pull Extension UPWARDS above table
surface... SLIGHTLY TIGHTEN 8CREW8 using
1/2 in. wrench.
Using small block of hardwood and hammer, tap
extension DOWNWARDS at front, center and rear,
until it is EVEN with table surface... TIGHTEN
SCREWS,
BLOCK OF WOO n
\
11
Loading ...
Loading ...
Loading ...