Loading ...
Loading ...
Loading ...
I
Replacing bottom plate
Reposition bottom plate and 4 Phillips
head screws. Tighten screws securely.
while turning agitator. To maintain
cleaning effectiveness, replace agitator if
brushes do not touch card.
What to buy
Your cleaner requires either a 13" or 15"
agitator. When purchasing a new
agitator, ask for one of the following:
13" - HOOVER part No. 48414110
15" - HOOVER part No. 48414115
I
How to replace
Disconnect cleaner from electrical
outlet.
Remove bottom plate, belt and agitator
following directions in "The belt" section
beginning with Fig. 3-10.
Discard old agitator.
Continue following the directions in "The
belt" section to reposition belt, new
agitator and bottom plate.
The edge groomers
When to replace
The edge groomers, located on both
sides of the nozzle, should be replaced
when they no longer extend past the
surface of the bottom plate.
What to buy
When purchasing edge groomers, ask for
HOOVER part No. 39511004.
Lubrication
The motor is equipped with bearings that
contain sufficient lubrication for the life of
the motor. The addition of lubricant
could cause damage. Therefore, do
not add lubricant to motor bearings.
The agitator is equipped with two ball
bearings that should be lubricated
periodically by a Hoover Factory Service
Cerlter or arl Authorized I Ioover Walr-
ranty Service Dealer (Depot).
How to replace
Disconnect cleaner from electrical
outlet.
Remove bottom plate P_s described in
"The belt" section (Fig. 3-10).
Installing groomers
Lift off both old edge groomers and slide
new edge groomers into position as
shown.
Reposition bottom plate and secure with
4 Phillips Plead screws.
Thermal protector
An internal thermal protector has been
designed into your cleaner to protect it
from overheating.
When the thermal protector activates,
the cleaner will stop running. Ir this
happens, proceed as follows:
1. Turn the cleaner OFF and disconnect
it from the electrical outlet.
2. Check secondary and final filters for
dirt accumulation.
3. Refer to "Clearing blockages"
section.
Service
To obtain approved HOOVER service and
genuine HOOVER parts, locate the
nearest Hoover Factory Service Center
or Authorized Hoover Warranty Service
Dealer (Depot) by:
• checking the Yellow Pages under
"Vacuum Cleaners - Household" OR
• checking the list of Factory Service
Centers provided with this Gleaner
OR-
" calling 1-800-944-9200 for an
automated referral of authorized
service outlet locations (U.S. only)
(bR-
If further assistance is needed, contact
The Hoover Company Consumer
Response Center, North Canton, Ohio
44720 Phone: 1-330-499-9499.
In Canada, contact Hoover Canada,
Burlington, Ontario L7R 4A8,
Phone: 1-800-263-6376.
Always identity your cleaner by the
complete model number when request-
ing information or ordering parts. (The
model number appears on the bottom of
the cleaner.)
Loading ...