Loading ...
Loading ...
Loading ...
To prevent the workpiece or backup material from being torn
from your hands while drilling, you MUST position the
workpiece against the LEFT side of the column, if the
workpiece or the backup material is not long enough to reach
the column, damp them to the table, or use the fence
provided with the drill press to brace the workpiece, Failure to
secure the workpiece could result in persona! injury,
USING THE FENCE (FIG. V)
The fence provides a way of accurately and quickly setting
up the workpiece for more precision or repetitive drilling
operations,
1. Using the centerpunch or sharp nail, make an
indentation in the workpiece where you want to drill
2. Lower the drill bit to align with the indentation on the
workpiece,
3. Loosen the knobs (1] and slide the fence back stop (2)
firmly aga_.nstthe long side of the workpiece, Tighten
the knobs when in position,
4, Loosen the wing nut (3] and slide the end stop (4) along
the fence until it is firmly against the left side of the
workpiece. Tighten the wing nu_
5. Check the accuracy by drilling a scrap workpiece.
Adjust if needed,
6, Hold with your hand or clamp the top surface of the
workpiece firmly to prevent it from lifting off the table
when the bit is raised.
Fig. V
Loading ...
Loading ...
Loading ...