Loading ...
Loading ...
Loading ...
Disconnect the drill press from the power source before
making any adjustments.
TOTI{LTTHETABLE (FIG,J)
NOTE: The table is not shown in Fig, J for clarity of
illustration.
1 Loosen the bevel lock (1) with a wrench.
2. Remove the horizontal locking pin (2) by turning the
nut (3) clockwise until the pin can be pulled from the
nole far enough to allow the table to move,
3, Tilt the table to the desired angle, using the bevel
scale (4) as a basic guide,
4. Tighten the bevel lock.
5, To return the table to its original position, loosen the
bevel lock bolt (1), Realign the bevel scale to the 0 °
setting,
6, Turn the nut (3} on the locking pin (2) counterclockwise
to the end of the threads.
7. Gently tap the locking pin until it is seated in the
hole. Finger-tighten the nut.
8. Tighten the bevel lock with a wrench.
Fig. J
(
/
4
3
TO SOUARE THE TABLE TO THE HEAD (FttG. K}
1 Insert a 3" drill bit (1) into the chuck (2), and tighten
by turning the chuck barrel counterclockwise,
2. Place a combination square (4) on the table (3) as
shown. The drill bit should be parallel to the straight
3. If an adjustment is needed, loosen the bevel lock (5)
with a wrench.
4. Square the table to the bit by tilting [he table.
5. Tighten the bevel lOCKwhen square.
Fig° K
_4_ 2
1
-- 4
3
TO MOVE THE TABLE (FIG, L)
t. Raise or lower the table (1) by loosening the support
lock handle (2).
2. Move the table to the desired position and tighten the
support lock handle.
Fig, L
FENCE ASSEMBLY {FIG. M)
1. Determine the desired location for the fence (1).
2 Align the mounting holes of the fence over the table
top slots.
3. Place a washer 12) on the threaded end of the knob [3),
Insert the knob through the mounting hole of the fence
and the table slot.
4_ Place a washer and wing nut 14}on the knob from
under the table.
5. Reoeat for the other knob and tighten.
Fig.M
11
Loading ...
Loading ...
Loading ...