Loading ...
Loading ...
Loading ...
TO DISPENSE ICE AND WATER
• Set the selector switch to CUBES, CRUSHED ICE
(on some models) or WATER.
• Grip the glass or other container near the rim and
press the rim against the center of the pad,
When Dispensing Ice:
* Some crushed ice may be dispensed even though
you selected CUBES. This happens occasionally
when a few cubes get channeled to the crusher.,
• Sometimes a mound of snow will form on the door in
the ice chute° This condition is normal, and usually
occurs when you have dispensed crushed ice
repeatedly The snow wiil eventually evaporate,.
• Sometimes crushed ice will spray beyond the glass.
To avoid this, hold the glass up close to the chute,.
When Dispensing Water:
. The first glass of water
dispensed may be warmer
than the following ones,.
This is normal
o Dispensed water is cool, not
iced. For colder water, simply
add crushed ice or cubes
before dispensing water_
CAUTION: Never put fingers or other objects into the
dispenser opening,,
TO STOP DISPENSING
Release pressure from the
pad and wait a few seconds
to catch the last bits of ice or
drops of water, There may be
some dripping after dispensing
of crushed ice or water° If there
is a lot of dripping, the spill
should be wiped dry right away.
Do not pour water in the spill
shelf because it is not self draining--pour it in the
kitchen sink. The shelf and its grille should be cleaned
regularly according to Care and Cleaning instructions.,
The grille is easily removed
by pressing on the back
right corner,
Press here to
remove grille
IF ICE CLUMPS FORM IN THE
STORAGE BIN...
The icemaker ejects cubes in groups of eight, and
it is normal for several cubes to be joined together°
However, if you don't use the ice very often ice clumps
may form in the storage bin and can clog the dispenser.
If this happens:
. Remove the storage bin from the freezer,
• Break up ice clumps with your hands Throw away any
clumps that you can't break uF
• Replace the bin before the remaining cubes melt and
fuse together°
• After washing the bin, allow it to cool before replacing
it, otherwise ice will stick to the metal auger.
TO REMOVE ICE STORAGE BIN
Lift the left corner to free the
bin from the shelf. Pull the bin
straight out while supporting it at
front and back.
TO REPLACE ICE STORAGE BIN
Slide the bin back until the
tab on the bin locks into the
slot in the shelf,,
If the bin does not go all the
way back, remove it and turn
the drive mechanism 1/4 turn.
Then push the bin back again
until the tab on the bin locks
into the slot in the shelf,
19
Loading ...
Loading ...
Loading ...