Loading ...
Loading ...
Loading ...
[_] CONNECT THE TUBING TO THE
REFRIGERATOR.
Electrical Shock Hazard
Before making the connection to the refrigerator,
be sure the refrigerator power cord is not plugged
into the wall outlet
We recommend installing a water filter if your water
supply has sand or particles that could clog the screen
of the refrigerator's water valve, Install it in the water line
near the refrigerator.,
a. Remove the plastic flexible cap from the water valve
b. Place the compression nut and ferrule (sleeve) onto
the end of the tubing as shown,
c. Insert the end of the copper tubing into the water
valve connection as far as possible, While holding
the tubing, tighten the fitting,
d° Fasten the copper tubing into the clamp provided
on the back of the refrigerator. You may need to pry
open the clamp This will hold the tubing in position
and prevent leaks when the refrigerator is pushed
away from the wall,
One of the illustrations below will took like the
connection on .your refrigerator,
_Tubing
1t4" Copper "/_ Clamp
x',
'_ 114"
] Compression
Remove i.- Nut
screws and
fold back
access (sleeve)
cover _ Refrigerator
Connection
Tubing Clamp f--.. 114" _ ....
"_ L_,I"_ Compression _-errute_sleeve)
_7 ? ) Nut _ _.,-_/t Refrigerator
114 Copper-----__ _1
Tubing ",,...'_'_
TURN THE WATER ON AT THE
SHUTOFF VALVE.
Tighten any connections that leak,
E_] PLUG IN THE REFRIGERATOR.
Arrange the coil of copper tubing so that it does not
vibrate against the back of the refrigerator or against
the wall
Check for leaks again after 24 hours.,
Push the refrigerator back to the wall.
[_] START THE ICEMAKER.
Set the icemaker feeler arm to the ON (down) position,
The icemaker will not begin to operate until it reaches its
operating temperature of 15°F (-9°C) or below It wilt
then begin operation automatically if the icemaker feeler
arm is in the ON (down) position,,
NOTE: The icemaker may double-cycle when it first
starts, causing some water spillage from the icemaker
into the ice bucket This is normal and should not
happen again
[] THROW AWAY THE FIRST FEW
BATCHES OF ICE CUBES.
Once the icemaker is in operation, throw away the first
few batches of ice cubes This will flush away impurities
in the water line.
Refer to Ice Service and lce and Water Dispenser
sections for steps to take before using your dispenser
and icemaker
I0
Loading ...
Loading ...
Loading ...